CBE MTCO Kullanıcı Kılavuzu - Sayfa 5

Gaz Dedektörleri CBE MTCO için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. CBE MTCO 12 sayfaları. Carbon monoxide (co) detector

INSTALLATION

The appropriate positioning of the detector is a fundamental prerequisite for the correct functioning; the detector

must be installed at "nose height" of the user (150-200 cm from the floor) near the area where people generally

stay or near the possible source of gas.

In order to establish the optimal positioning of the detector it is advisable to ask for an advice from a specialised

technician.

The detector can be built-in or fixed to the wall with the spacer supplied.

The module can be combined with other CBE and Truma modules to be completed with the installation of frames

of the "Modular Plates" range.

Built-in fixing

After having turned on the detector with the front switch (ref. 1), the heating procedure of the detector continues

for approx. 60 seconds and is indicated by a red led (ref. 2).

At the end of the heating procedure, the detector is ready to signal any alarming situation. The operating mode is

indicated by the flashing of the red led (ref.2) (1 flash every 2 seconds).

When the gas concentration exceeds the limit established, the acoustic (

visual (red led always on) alarm starts functioning.

The alarm continues to operate until the detector is turned off.

Input voltage

Absorbed current, typical

Absorbed current, alarm

Operating temperature

Humidity

Heating time

Acoustic power

Alarm threshold

Detector life

Dimensions (mm)

buzzer with a continuous sound

12 Vdc

10 mA

12 mA

-10÷40 °C

30÷95%

60 sec.

85 dB at a distance of 1 metre with external buzzer

300 PPM within 3 min.

Reference EN 50291

10 years

60x60x20 max

Wall-fixing

) and