Datamax E Class E-4204 Hızlı Başlangıç Kılavuzu - Sayfa 2
Yazıcı Datamax E Class E-4204 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Datamax E Class E-4204 2 sayfaları. E class series
Sayfayı Yazdır
a) Ensure that the Media Type
Switch is in the Transfer
Í
position:
Media Type Switch
Ribbon Loading
(perform only if
equipped with the
optional
Thermal Transfer
feature)
Î
Printer Front
Panel
'
With the printer 'On' and loaded with 4 inch wide media (and
ribbon, if needed):
+
Press the
the Database Configuration Label.
Test Label
Printing
b) Remove and load the Hubs:
Direct
Transfer
Slide a Ribbon onto a Hub and
an Empty Core onto a Hub
Empty Core
buttons simultaneously; this will print
c)
Replace the Hubs so that
the ribbon flows as shown
below:
Push in and lift
to remove the Hubs
Ribbon
þ Note: Ensure the inked side of
the ribbon faces the
media and NOT the
printhead.
'
This table contains a list of the
printer's menu items and the
associated default values.
These values can be changed
in the Printer Setup Mode.
Additional
Information
Ÿ
For unpacking/repackaging information see the Operator's Manual.
Ÿ
Follow and perform the suggested maintenance as detailed in the Operator's Manual.
Ÿ
For detailed information on the topics referred to in this guide consult the Operator's
Manual; for detailed information on custom programming see the E-Class Programmer's
Manual included on the Accessories CD-ROM.
Contacting Datamax...
Corporate Headquarters
Technical Support
d) Route the ribbon through the printer, as shown below:
Wrap the end of the ribbon
around the Empty Core
and secure it in place
PRINTER SETUP MODE DEFAULT VALUES TABLE*
#
Menu Item
Default
#
Value
1
MEDIA TYPE
DIRECT
11
OOS MAXVOLT
2
SENSOR TYPE
EDGE
12
TOF GAIN
3
PRESENT SENSOR
NO
13
TOF DELTA
4
CUTTER EQUIPPED
NO
14
TOF LOW
5
SOP ADJUST
128
15
LABEL WIDTH
6
PRESENT ADJUST
128
16
SCALABLE FONT
7
BAUD RATE
9600
17
INTERNAL MODULE
8
DATA, PARITY
8, N
18
LABEL ALIGNMENT
9
CONTROL CODES
STANDARD
19
ALIGN LENGTH
10
CONT FORM LENGTH
100
20
STOP LOCATION
21
INPUT MODE
*Certain item values can also be controlled via software.
(407) 578-8007
(407) 523-5540
Menu Item
Default
Value
2
10
10
0
410
64
128
NO
100
HOST
DPL