agri supply PTOW3 Kullanıcı El Kitabı - Sayfa 8

Su Pompası agri supply PTOW3 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. agri supply PTOW3 12 sayfaları.

7. Fill priming water

WARNING:

Not allowed start water pump if water pump is not fill water fully. Not allowed

start water pump if Gearbox box is not fill to proper oil level.

STARTING THE WATER PUMP

Follow these steps to start the water pump:

1.Fill water full to water pump.

2.Fill oil to proper level to gearbox

3. Start the tractor engine

4.Choose correct gear and engage the power takeoff (PTO) drive.

5. Slowly increase tractor engine speed while observing water pump running till pump out

water，adjust engine speed to rated speed.

STOPPING THE WATER PUMP

Follow these steps:

1. Release the cluth, Let tractor engine run for a few minutes at no-load, to cool internal parts.

2. Shut OFF the tractor engine.

3. Clean water pump

4. Remove the power takeoff (PTO) shaft from water pump and tractor.

8. Maintenance

Your water pump set will perform reliably only if you properly maintain it. This section outlines

the minimum recommended periodic maintenance to keep your unit in good condition and

increase its life. If operating your water pump under extremely adverse conditions (extreme dust,

dirt, cold or heat), increase periodic maintenance frequencies accordingly.

VISUAL INSPECTION

Carefully inspect the water pump set before you first use it and at least once each month

thereafter. Look for the following discrepancies:

1. Loose or broken parts

2. Defective connections

3. Missing, corroded or damaged fasteners and other hardware

4. General appearance and cleanliness