Datapath VisionSC-SDI4 Kullanıcı Kılavuzu - Sayfa 11

PCI Kart Datapath VisionSC-SDI4 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Datapath VisionSC-SDI4 16 sayfaları. 3g-sdi video capture card
Ayrıca Datapath VisionSC-SDI4 için: Hızlı Başlangıç Kılavuzu (2 sayfalar)

Sayfayı Yazdır

Installing the Capture Card

You are likely to need a flat blade and /or a cross head screwdriver for the installation of the

VisionSC-SDI4 card; it would be useful to have these to hand before you begin.

•

Power down the PC (including peripherals), switch off at the mains and disconnect all the cables

connected to the computer, noting the positions for accurate re-connection

•

Remove the PC cover

•

Locate a vacant PCI Express slot (x4 or higher) on the motherboard and remove the blanking plate

(retain all screws)

PCI Express slot. If the card is forced into a 32 or 64 bit PCI or PCI-X slot it will be irreparably damaged

when the system is powered up and the warranty will be void.

•

Reconnect all cables to the PC

•

Power up the PC and commence the software installation

How to Connect Input Sources

The VisionSC-SDI4 card has four BNC type connectors for four separate, simultaneous inputs. The

connectors have green LED's. Connect the cables distributing the video source signal to BNC input

connectors on the VisionSC-SDI4 capture card.

When connecting BNC cables, ensure connectors are fully twisted and locked in place. Failure to lock the

connector can result in the BNC cable becoming separated from the card and the connection being lost.

Cable Lengths

The VisionSC-SDI4 supports cable lengths of up to 150m for 3G-SDI. This figure is based on using low loss

coax cables (Belden 1694A). Avoid tight loops or kinks in the cables.

If you are in doubt consult your motherboard documentation to correctly identify a

Fig. 3

Fig. 4