DUUN 140001 Kullanım Kılavuzu - Sayfa 11
Çiftlik Ekipmanları DUUN 140001 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. DUUN 140001 16 sayfaları. Wood grab
Ayrıca DUUN 140001 için: Kullanım Kılavuzu (9 sayfalar)
Sayfayı YazdırPreparation for use
Adjustment of skid pads
The snow blower is placed on a level surface and the skid pads are adjusted so that the wear steels
on both sides + the infeed steel in front of the fan housing have clearance above ground level. Too
small distance here will cause abnormal wear on both wear steel and feed steel.
Power transmission shafts
Make sure that the PTO shaft is of sufficient length. After any length adjustment, the profile pipes in
the shaft must overlap each other by half the pipe length. Any cutting of the shaft is carried out
accordance to the instructions for this – the cut point is chamfered inside and out, and the profile
tubes are lubricated with grease. Too short a telescopic length on the shaft entails a risk of
overloading the tractor's PTO and the snow blower's bearings.
Please lubricate the power transmission shaft before use.
The shear bolt coupling on the shaft is mounted against the implement. The coupling has a capacity
of 4180 nm and in the event of a break in this, a hexagonal screw dim 12 mm qual 8.8 must be used
as a breaking pin. The locking chains for the protective covers must always be attached to suitable
fasteners to prevent the covers from rotating.
The power transmission shafts are maintained and used according to the attached instruction
manual.
Save control of greasing (lubrication)
Check that the warehouses (front and back) are lubricated. Lack of lubrication entails a risk of
breakdown. Also, be careful not to "over-lubricate" the bearings as this entails the risk of heat build-
up and overheating in the bearing itself. In the case of too little lubrication, water can penetrate
(infiltrate) the bearings.
Lubrication of ball bearing
Check that this is lubricated and make sure it is lubricated before use if this is not the case. Too little
lubrication causes abnormal wear on the gears and chain.
Lubrication of feeding blade
Check that this is lubricated and make sure it is lubricated before use if this is not the case. Too little
lubrication causes abnormal wear on the gears and chain.
Protection of hydraulic hoses
Check the hose connections and that they are not stretched or cut during use. Tighten loose hose
connections and secure/fasten the advance of the fittings. Failure to secure hydraulic hoses can lead
to leaks and consequential damage to tractors and components.
11