DataRemote CDS-9010 Hızlı Başlangıç Kılavuzu

Kablosuz Yönlendirici DataRemote CDS-9010 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. DataRemote CDS-9010 2 sayfaları.

Sayfayı Yazdır

CDS-9010

QUICK START GUIDE

For more information on

how to conﬁgure your DATAREMOTE

CDS-9010 Device, please visit

Support.DataRemote.com

IMPORTANT:

Before starting to conﬁgure the router, you have to

connect your devices correctly, follow these "step by

step" directions as shown below. If you have any

questions regarding installation, please contact your

Support Team

STEP 1

If your new device did not come with a SIM card

pre-installed, please follow the SIM install directions:

Inside the right battery port, the SIM card slots are located

on the left bottom corner of your device. Insert the SIM

card inside the slot marked "SIM 1". Make sure is inserted

all the way into the slot. You will feel a spring lock the SIM

card into place.

Then Insert the batteries in to the battery ports on the

sides of your CDS-9010 device, making sure they will click

in place correctly. Then connect one end of the power

cord to the power port of your device. Finally, connect the

other end to an electric outlet.

STEP 2

Connect the WAN cable from your modem, switch or

router to the WAN port of your device, with an Ethernet

(RJ-45) cable.

DISCLAIMER: This is just a representation of a modem, models and

appearance may vary depending on your Internet provider.

STEP 3

Connect to one of the two LAN ports on your device with

an Ethernet cable (RJ-45) to your equipment or computer

that needs to receive an Internet connection from the

CDS-9010. Your device allows you to connect up to two (2)

devices for Internet access.

STEP 4

Connect the RJ-11 (Phone line) from your phone or

equipment requiring a phone line to the DataRemote

CDS-9010 device's FXS port.

WARNING!

Do not connect an active RJ-11 with voltage directly from the wall

into the DataRemote device's RJ-11 ports, this will damage the

device permanently. Each DataRemote device's RJ-11 FXS port is

an active port supplying voltage. The FXS port is only to be

connected to an FXO analog phone or another FXO device.

Revision No. 005 August 2020