Auscision 442 Class Kullanım Bilgileri Kılavuzu

Oyuncak Auscision 442 Class için çevrimiçi göz atın veya pdf Kullanım Bilgileri Kılavuzu indirin. Auscision 442 Class 9 sayfaları.

Auscision Models 442 Class Operating Information.

Your Auscision Models 442 class locomotive's main printed circuit board and associated lighting has been

designed to function as a

made to the No.1 end and No.2 end of the model. This diagram will assist in identifying which end

is which:

Number 1, Front End.

DC Model

The DC model is able to control the locomotives lighting via the micro switches on the bottom of the

fuel tank. The lighting is directional. The switches are able to isolate, turn on/off:

1. The Locomotives Headlights.

2. The Locomotives Number Boards and White Marker Lights.

3. The Locomotives Red Marker Lights.

The lighting connection for the DC model has the

connected to the main printed circuit board at the two plugs marked

Boards connection is via a COMMON wiring plug that both the DC and DCC Sound Decoder Installed

versions use.

(See image on page 3)

If you're going to operate your model on a DC system /controller then read no further. If you plan on

fitting an after marker decoder or your model is a DCC Sound Ready model please read on.

DCC Ready Model - fitting an aftermarket decoder

The 442 class models main printed circuit board has been specifically designed to function through the

'NEM660 standards' 21pin connector and integrate with the new ESU Loksound V5 decoder. Via the 21

pin connector this decoder functions with four individually powered auxiliary outputs (Headlight front,

Headlight rear, Aux 1 and Aux 2) and four individual logic outputs (Aux 3, 4, 5, 6) which the main circuit

board has electronic components included for their operation. The DCC Sound Decoder Installed

models lighting connects via 3 separate plugs. One COMMON connection for the Headlights and

Number Boards, and two plugs marked 'DCC' for the appropriate ends marker lighting. (See image on

page 3)

Auscision 442 Class Operating Information (v3)

DC and DCC Sound Decoder Installed Model. In these notes reference is

Page 1 of 9

Number 1 and Number 2 end white/red marker lights

'DC'. The Headlights and Number

Number 2, Rear End.

'Radiator Fan End'