4ms Quad Clock Distributor Expander İnşaatçı El Kitabı - Sayfa 10

Mikrodenetleyiciler 4ms Quad Clock Distributor Expander için çevrimiçi göz atın veya pdf İnşaatçı El Kitabı indirin. 4ms Quad Clock Distributor Expander 12 sayfaları.

Sayfayı Yazdır

Step 14: Power up and calibration

Make sure to plug the power cable into the 2x5 header, NOT the 2x8 EXPANDER header. If you connect

the EXPANDER header to power, it will DAMAGE THE MODULE.

Use the supplied 10-to-16pin power cable to attach the 2x5 "POWER" header to a standard Eurorack

power supply. The red stripe on the cable should be down, matching the white stripe on the PCB.

Before turning on the power supply, use the 16-to-16pin cable to attach the EXPANDER header on the

QCD Expander to the EXPANDER header on a QCD module. The red stripe should be orientated down

on both the expander and the main module.

Power up, and tap the QCD's button to set a tempo. The lights on the QCD Expander should flash. If not,

unplug immediately and check around for errors. Make sure both cables aren't backwards. Feel all the

ICs and the 7805 to see if anything got hot. If there's a problem, skip to the Troubleshooting section.