Auspex Fire Manuel - Sayfa 10

Güvenlik Ekipmanları Auspex Fire için çevrimiçi göz atın veya pdf Manuel indirin. Auspex Fire 16 sayfaları.

Sayfayı Yazdır

Making A Joint

Auspex fittings from 16mm-25mm use a copper crimp ring

connection and can be crimped with an Auspex manual tool

or a Rothenburger battery tool.

The 32mm Auspex water fitting has a Stainless Steel

crimp ring and can only be crimped with the battery tool

using a DuoPEX jaw (see page 9). The DuoPEX jaws are

universal across all systems shown below.

DuoPEX Gas

fittings are defined

by the yellow

plastic holding ring

and are for use only

with the multi-layer

DuoPEX Gas pipe.

It is most important that the tool manual supplied with the

tool is read in its entirety and the user becomes familiar with

the maintenance, calibration and proper use of the tool.

Step 1.

Measure the pipe to the

correct length and using a

secateur-type pipe cutter,

cut the pipe squarely and

remove any burrs. The end

of the pipe may need to be

freshly cut to ensure smooth

passage for the fitting.

Do not use a hacksaw.

Step 2.

The pipe is pushed over the

barbed fitting and at the

same time under the crimp

ring. The fit should be firm.

If the joint feels sloppy or

hard to insert, check pipe

and fittings. Do not use

lubricants. Ensure the pipe

is visible in both crimp ring

witness holes.

Auspex Fire Manual

DuoPEX Water

fittings are defined

by the blue plastic

holding ring and are

for use only with the

multi-layer DuoPEX

Water pipe.

The witness holes should

be completely filled.

Auspex 32mm water

fittings are defined by the

clear plastic holding ring

and are for use only with

the single layer Auspex

water pipe and multi-

layer Auspex Gas pipe.

witness hole