Aussie 4280 Walk-A-Bout Gas Kullanıcı Kılavuzu - Sayfa 4

ızgara Aussie 4280 Walk-A-Bout Gas için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Aussie 4280 Walk-A-Bout Gas 16 sayfaları. Lp gas grill

Sayfayı Yazdır

Set-Up Instructions

CAUTION

PINCH HAZARD

To reduce the risk of bodily

injury from pinch hazard, keep

hands and fingers away from

hinges and leg pivot points.

Read and follow these instruc-

tions to set up your grill.

Step 3

Swing Legs away from grill body until

they are straight out as shown.

Step 6

Stand facing the top of the hood and

grasp the grill by the Control Panel

Handle and the hood flange at the rear.

Lift and rotate the grill until it is standing

upright on the ground.

Step 1

Lay grill on its side. Place on grass or a

soft surface to prevent paint damage.

Step 4

Grasp the inner leg near the grill body

and pull it toward the back of the grill.

Step 7

Install the Wire Grease Cup Holder by

first removing the Cooking Grid. Next,

holding the Wire by the small loop at the

top, thread the end down through the

small hole in the center of the bottom of

the grill bowl until the wire is hanging by

the small loop.

Step 2

Swing Pivot Latch away from the Leg

Crossrod to allow the legs to pivot.

Step 5

Slide the Leg Hook Wire on to the Bowl

Bracket until it stops at the back of the

Bracket. Be sure to allow the Safety Latch

to drop down behind the Leg Hook to

prevent the Hook from sliding off of the

Bracket.

Bowl

Bracket

Leg Hook

Step 8

Install the Grease Cup in the Wire

Holder by reaching under the grill

and sliding the cup into the wire.

Replace the Cooking Grid.

Wire

Grease Cup

Holder

Grease Cup

Pivot Latch

Leg

Crossrod

Safety Latch