Aussie Concept F140 Kullanım Kılavuzu - Sayfa 9

Basınçlı Yıkama Aussie Concept F140 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Aussie Concept F140 13 sayfaları. Domestic cold water high pressure cleaner

Sayfayı Yazdır

DETERGENT APPLICATOR (CLEANING AGENTS)

Step 1: -

Fill detergent tank with detergent:

The Concept F140 detergent tank is incorporated into the

chassis of the machine.

never pour detergent into the tank unless it has been diluted

down. If the detergent is too thick, this will cause blockage

through the detergent injector (Fig. 7).

Step 2: - The vario nozzle on the Concept F140 has a separate

extreme low pressure function which creates a venturi

(suction feed) to allow the detergent to self feed through the

detergent injector. To perform this operation, the vario

nozzle on the machines listed above can be clicked forward,

creating the venturi. The nozzle should click forward approximately 2cm. The

detergent will only operate when the unit is on its extreme low pressure function.

Step 3. - Once operator has finished with the detergent, then warm water should be filled

into the detergent tank and Step 2 should be repeated to avoid the detergent

sticking inside the detergent injector of the machine.

Never let detergent dry on objects.

Never use caustic or acidic materials through detergent function facility.

TOTAL STOP ADJUSTMENT

Total Stop is a unique device that automatically turns the machine off when the operator

releases the trigger. Total Stop can move out of adjustment through wear or being knocked or

jarred.

IMPORTANT: Aussie Eco-Clean recommend o-rings must be replaced when carrying out any

maintenance and repair work. All moving parts, screws and sealing rings must be coated in

marine grease prior to use.

accessories can cause the Total Stop function not to work (this will cause the machine to

pulsate).

NOTE: The machine's permissible working pressure has been set on

the safety unloader by the manufacturer and MUST NOT BE

CHANGED. The unloader is sealed for this reason. The permissible

working pressure must be re-set after all repairs and the unloader re-

sealed with paint on unloader lead.

REMOVAL AND INSTALLATION

Remove motor and pump group from chassis and covers.

Unscrew hex bolts (Fig. 8).

Take note of adjusting screw for micro switch, the o-rings and

the delivery valves.

To replace unloader remove bypass valve.

Insert adjusting screw (Fig. 9) in the opening of the micro

switch (Total Stop).

Fix fastening screws and torque to 7NM, working crosswise.

Set working pressure when machine cuts off when the trigger

is released.

Repaint unloader seal.

If you do not feel confident to carry out this adjustment, take your machine

to your local authorised Aussie Pumps Service Agent.

When filling the detergent tank

Water leaks internally in the pump or on the high pressure

Concept F140 Cold Water Pressure Cleaners – March 09

Fig. 7

Fig. 8

Fig. 9

Page 9 of 12