Agri-Fab 45-02104 Kullanıcı El Kitabı - Sayfa 4

Serpme Agri-Fab 45-02104 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Agri-Fab 45-02104 13 sayfaları. Agri-fab 125 lb. push broadcast spreader owner's manual

Sayfayı Yazdır
ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED FOR ASSEMBLY

(1) Pliers
(1) Hammer
(2) 7/16" Open or Boxed End Wrenches
1.
Remove the spreader, the loose parts and the hardware
package from the carton. Lay out parts and hardware
and identify using the illustrations on pages 2 and 3.
2.
With the spreader resting upside down on the top of
the hopper, assemble a spacer and then a 5/8" flat
washer onto each end of the axle. See figure 1.
AXLE
SPACER
5/8" FLAT
WASHER
FIGURE 1
3.
Place a wheel onto the end of the axle that has no
cross hole. The long end of the hub goes to the inside.
See figure 2.
4.
Place a 5/8" flat washer onto the axle and then lightly
tap a hub cap onto the axle until it is snug against the
washer and wheel hub. See figure 2.
NO CROSS HOLE
WHEEL
FIGURE 2
5/8" FLAT
WASHER
HUB CAP
5.
Place a wheel onto the end of the axle that has a cross
hole. The long end of the hub goes to the inside. See
figure 3.
6.
Assemble a 5/32" x 2" cotter pin through the hole in
the wheel hub and the axle. See figure 3.
7.
Place a 5/8" flat washer onto the axle and then lightly
tap a hub cap onto the axle until it is snug against the
washer and wheel hub. See figure 3.
CROSS
FIGURE 3
8.
Remove the nut from the middle bolt in the crossover
tube. See figure 4.
CROSSOVER
TUBE
MIDDLE BOLT
FIGURE 4
4
5/32" x 2"
COTTER PIN
HOLE
5/8" FLAT
WASHER
MIDDLE NUT
SHAFT
SUPPORT
PLATE
HUB CAP