Datatool EVO PRO Kullanıcı Kılavuzu - Sayfa 5
Motosiklet Aksesuarları Datatool EVO PRO için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Datatool EVO PRO 5 sayfaları.
Ayrıca Datatool EVO PRO için: Kurulum Kılavuzu (9 sayfalar)
Sayfayı Yazdır4.0 - PROGRAMMABLE FEATURES
The alarm is factory preset with the following features enabled:
Factory settings
Feature
Acoustic signals
Panic alarm
to confirm arming/disarming, alarm memory,
!
Acoustic signals:
programming and learning of new devices.
!
for use in emergency situations. Panic alarms can be
Panic alarm:
triggered as many times as necessary, but at least 5 sec. must elapse
between 2 consecutive alarms. Pressing button 2 will immediately trigger
the siren and the turn indicators for approx. 30 seconds.
To turn OFF the panic alarm, press button 2 again.
5.0 - SLEEP MODE ACTIVATION/DEACTIVATION
If the vehicle will be sitting idle for long periods of time, the alarm can be
switched off (Sleep Mode) to preserve battery life.
To activate Sleep Mode, proceed as follows:
Turn ignition key ON; the LED will light up for approx. 1 second.
!
Touch the override key to its receptacle within 4 seconds.
!
A Beep will confirm the alarm has been turned off.
!
Turn ignition key OFF.
!
To restore normal operation, turn ignition key ON and then OFF.
!
6.0 - USE AND MAINTENANCE
Care should be taken to protect the electronic alarm system:
Do not clean the alarm with water but use a damp cloth to wipe.
!
Do not expose the alarm to heat sources.
!
Do not use voltages other than the one specified by the manufacturer.
!
Protect the alarm from any direct water flow, such as a high-powered water
!
jet found in a car wash.
Page 8
State
Enabled
Enabled
7.0 - REPLACING REMOTE CONTROL BATTERIES
If the batteries are running low the status LED will blink at the press of a button.
To replace the batteries proceed as follows:
Remove the
Separate the shell
discharged batteries
halves taking care
and insert the new
not to damage the
ones taking care not to
internal circuit.
invert the polarity.
!
WARNING
U
se only CR1616 batteries.
Different type batteries can seriously damage the remote control unit.
Discard used batteries properly in special dedicated containers
8.0 - WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT
The present device falls within the field of application of the current WEEE
Directive. The crossed-out wheeled bin symbol on the equipment or on its
packaging indicates that the product, at the end of its useful life, must be
discarded separately from other waste to allow adequate treatment and
recycling.
The user must therefore take the equipment, at the end of its useful life, to an
appropriate waste collection facility.
Close the plastic
shells and make
sure the remote
works properly.
.
Page 9