AUSSIE TONNEAU ATB01123 Montaj Talimatı - Sayfa 3

Otomobil Aksesuarları AUSSIE TONNEAU ATB01123 için çevrimiçi göz atın veya pdf Montaj Talimatı indirin. AUSSIE TONNEAU ATB01123 3 sayfaları. Cover for toyota sr5

Sayfayı Yazdır

3. MULTI-FIT SUPPORT BAR

The Aussie Tonneau Multi - Fit Support Bar is designed to fit almost all Utes on the Market, from Suburu Brumbys

to Cab Chassis aluminium trays.

3.1 BASIC TOOL REQUIRED

Drill, 4mm drill bit

3.2 MULTI-FIT SUPPORT CONTENTS

1 x hollow bar centrepiece

2 x solid bar end piece

3.3 FITTING MULTI-FIT SUPPORT BAR

1. Insert solid bar pieces into either end of hollow tube. Adjust bar so it fits between bar bracket holders

with the holes facing to the ground (so the grub screws don't rub against the tonneau), as shown above

and then with a white pencil make a mark through the small holes of the hollow bar onto the solid ends.

This is where you will drill a hole to the depth of about 1-2mm (do not go any further)

2. Join the pieces back together and screw grub screws through the hollow bar into the holes that you

drilled. Make sure you do not over tighten the grub screws. Refit the bar. You may kink the bar in the

middle to give it some extra height to assist with water runoff.

2 x grub screws