ADE M501660 Kullanım Kılavuzu - Sayfa 7

Terazi ADE M501660 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. ADE M501660 12 sayfaları. Hanseat

Tare function

The tare function allows ignoring a fixed weight (e.g. wheelchair) that will be deducted after each

weighing procedure. Proceed as follows:

Press the start key with no load on the scale.

Place the additional weight of the object(s), which needs to be ignored, on the scale and store

the result by pressing the TARE key.

The display is being reset to zero. The scale is now in NET weighing mode which is also

indicated on the display.

Remove now the objects from the platform. The ignored weight is being displayed with a

minus.

Place the Patient and the additional weight (e.g. in the wheelchair) on the scale.

The scale determines the weight of the patient without the additional weight. You may now

use the scale for as many weighing procedures and the stored value will always be deducted

as long as the scale is not turned off.

Enter the tare button again to get of the tare mode.

The tare value is likewise erased by the scale until pressing the tare button or being switched

off.

To input a pre set tare value press down the tare button more than 3 seconds. NET will appear at the

screen. Follow the same steps as before and place a load on the platform. The last stored tare value

will appear at the display and ignored by the scale.

The Hold function is being used if you like to hold the results at the display after the weight/load has

been removed from the scale. Use this button to take care of the patient first and then note the weight.

Press HOLD key while scale is under load.

"HOLD" is being displayed at the screen.

The weight remains saved in the display after unloading the scale.

For deactivation of the Hold function press again the HOLD key.

The Body Mass Index is the ratio between height and weight squared. The BMI is accepted world wide

– also by WHO (World Health Organization) - helping to evaluate the state of nutrition and with that

value also the state of health of a person. The result is a tolerance value.

Start the scale by entering the ON/OFF Button. The scale is automatically being set to zero.

Step on the scale or helping the patient to get into the wheelchair and on the platform.

Wait until the weight is being displayed in a stable condition and

Press the BMI key shortly.

The scale starts automatically with the last input. Use the arrow buttons to enter the height of

   

the patient.

The BMI is now being displayed at the indicator.

To correct the given height press the BMI button once again and the display returns to the

height mode.

To get back into normal weighing mode and leave the BMI modus press the tare button.

M501660-210512-Rev003-UM-e

Confirm the height with the enter button .

´ appears on the screen.