ADE M703600-01 Kullanım Kılavuzu - Sayfa 3
Terazi ADE M703600-01 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. ADE M703600-01 12 sayfaları. Electronic lifter scales
This symbol means: "Consult operating instructions". To achieve accurate results,
read the instructions for use carefully before use and follow all instructions provided
therein. Keep the instructions for use for future reference.
Before weighing
Your ADE scale is a quality product. Before weighing please read this manual thoroughly and strictly
follow the instruction. Keep it properly for future use.
Safety Guide
For utmost performance and precise measurement, please follow carefully operation and
maintenance instructions herein mentioned.
Do NOT overload the scale. This will damage the load cell and automatically invalidate the warranty.
Do NOT keep any load on the scale for longer than necessary. This will decrease the scale's accuracy
and shorten the load cell's lifetime.
Before using the scale make shackle and hook are connected properly.
Once the power supply is running low please change batteries.
Do NOT use the scale under weather conditions which may influence the weight results by electronic
interference.
Do NOT open the scale. In case of any default contact your local representative.
Make sure no water or cleaning fluid is penetrating the scale.
Check carton contents
Electronic Lifter Scale
2 Safety hooks (1 shackle link, 1 stable S-hook)
3 x AA Batteries
Operating Manual
Insert batteries
Open the battery compartment on the backside of the scale by sliding the lid aside.
Insert 3 x AA Batteries respecting the pole markings.
Shut the battery compartment carefully and make sure it is completely closed.
In case display shows 'LO' batteries are flat and need to be replaced.
Installation of scale to a suitable person lifter
Insert the shackle link into the upper the S-hook into the lower suspension of the scale.
Remove the suspension yoke of the person lifter and replace this by using the upper suspension
eye of the scale to combine lifting arm and scale.
Slide the suspension respectively the carrying equipment of the person lifter carefully into the S-
hook.
Weighing
To achieve a reliable result make sure the scale in always in vertical position. The S-hook must not yet
be loaded by any weight. Press the ON key to start the scale. After a short function test the display
becomes stable, the scale has found its zero point and shows '0.00' kg.
M703600+M703600-01-210817-Rev008-UM-en
Safety Instructions
Getting started
3