DVIGear DVI-7312 Hızlı Başlangıç Kılavuzu - Sayfa 3

Genişletici DVIGear DVI-7312 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. DVIGear DVI-7312 4 sayfaları. Single-link dvi fiber optic extender, 2x lc

Sayfayı Yazdır

Single-Link DVI Fiber Optic Extender, 2x LC

1. DVI Connector

2a. EDID LED

2b. POWER LED

3. Fiber Optic Connectors

4. DC IN Connector

5. Learn EDID Button

Note: The DVI-7312-TX Transmitter Unit and DVI-7312-RX Receiver Unit use the same type

of enclosure and have the same connections.

Installation Instructions

This product consists of a DVI-7312-TX Transmitter Unit and a DVI-7312-RX Receiver Unit. These units

are interconnected by means of a two-channel LC optical cable utilizing either 50/125μ multi-mode fiber,

or 9/125μ single-mode fiber (see application drawing on page 1).

1.)

Learn the EDID from the destination device (see instructions on page 4).

2.)

Connect the Transmitter Unit to the DVI output port of the signal source (e.g. PC).

3.)

Connect the Receiver Unit to the DVI port of a destination device (e.g. digital display).

4.)

Each unit has two (2) Optical ports which are marked on the bottom of the unit with the

numbers 1 and 2. Connect each strand of the LC terminated fiber optic cable to the

corresponding number on both the Transmitter and Receiver Units.

5.)

Connect the External AC Power Adapter to the power input jack on the Receiver Unit.

6.)

Apply power to the display device, then apply power to the source device. A picture should appear

on the display within a few seconds.

Power Sources

The Receiver Unit must draw power from the supplied External AC Power Adapter. It does not draw

power from the monitor to which it is connected. However, the Transmitter Unit can draw power from

the source device for operation. In the event that the source cannot provide adequate power for the

transmitter, an optional External AC Power Supply is available (part number DVI-7210-PS).

Quick Start Guide

DVI-7312-TX connects to source, DVI-7312-RX connects to display

(Top side) Illuminates Blue when EDID has been read successfully

(Bottom side) Illuminates Red when DC power is applied

2x LC optical connectors for fiber optic cables

Connect the External AC Power Adapter to this receptacle

Use a stylus to actuate this switch following the procedure on page 4

DVI-7312