DVIGear DVI-7320 Kullanıcı Kılavuzu - Sayfa 7

Genişletici DVIGear DVI-7320 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. DVIGear DVI-7320 11 sayfaları. Dual-link dvi fiber optic extender
Ayrıca DVIGear DVI-7320 için: Kullanıcı Kılavuzu (10 sayfalar)

Sayfayı Yazdır
The DVI signal components are routed from the DVI-7320-Tx to the DVI-7320-Rx
via two distinct signal paths: the low-speed signals are sent over a copper CAT5
cable link, and the high-speed TMDS and clock signals are sent over seven (7)
Multi-Mode fiber optic cables with LC connectors (see the diagram on page 6).
When the DVI-7320-Tx unit is set for Real DDC operation, a CAT5 copper cable
of suitable length must connected between the DDC ports of the DVI-7320-Tx
and DVI-7320-Rx units.
Each unit has seven (7) Optical ports that are marked with the numbers T1, T2, T3,
T4, T5, T6, and T7 on the DVI-7320-Tx unit, and R1, R2, R3, R4, R5, R6, and R7
on the DVI-7320-Rx unit. It is important to connect each LC fiber optic cable to
the corresponding number on both the DVI-7320-Tx and DVI-7320-Rx units.
TMDS Signal
Designation
CLK
D0
D1
D2
D3
D4
D5
Note 4-2: If present, the 8th fiber optic cable does not need to be connected as all signals
are transmitted over cables 1-7. The 8th fiber optic port (to the left of port T7 or R7) is
unmarked and is a dummy port.
The DVI-7320-Tx unit can be powered by the DVI source only if the source device
can provide sufficient drive current on Pin 14 of the DVI output connector. If this
is not the case, an optional External Power Adapter (p.n. DVI-7320-PS) may be
required to power the DVI-7320-Tx unit.
The DVI-7320-Rx unit cannot draw power from the connected display, but it can
receive power from the DVI-7320-Tx unit, provided a copper CAT5 cable is used
to link the DDC ports. If a CAT5 cable is not used, then connect the supplied
External AC Power Adapter to the power input jack on the DVI-7320-Rx unit.
Note 4-3: If a CAT5 cable is used to link the DDC ports of both units, then only one (1)
External AC Power Adapter is needed, which can be connected to the DVI-7320-Tx unit.
Optical Port Assignments
Description
Clock
Blue
+ Sync
1
Green
1
Red
1
Blue
2
Green
2
Red
2
-5-
DVI-7320-TX
Tx Port No.
T1
T2
T3
T4
T5
T6
T7
DVI-7320-RX
Rx Port No.
R1
R2
R3
R4
R5
R6
R7