Frigidaire 241856001 Kullanım ve Bakım Kılavuzu - Sayfa 12
Buzdolabı Frigidaire 241856001 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Kılavuzu indirin. Frigidaire 241856001 19 sayfaları. Frigidaire side by side refrigerator use & care manual
Sayfayı Yazdır
PURESOURCE
* ICE AND WAtER fILtER
tm
(SOmE mODELS)
Order new filter cartridges through the dealer where you
bought the refrigerator, contact the Electrolux Solutions Hotline
at 1-800-944-9044, or go to our web site at www.frigidaire.
com. It might be good to order some filter cartridges when
you first install your refrigerator. Be sure to ask for the RG-100
PureSource™* replacement cartridge.
system startup:
Water supply does not need to be turned off, however, do not
use ice and water dispenser while installing filter. The filter
cartridge has already been installed in the filter housing at the
factory. Refer to the How to Prime the Water Supply System
section to properly fill the system with water.
The PureSource™ * NGRG-2000 Ice and Water
Filter System with the RG-100 cartridge is
tested and certified by NSF International, the
nationally recognized and respected, not for
profit, certification organization for public health
safety. The PureSource™* system is tested and certified
to ANSI/NSF Standard 42. See performance data sheet for
specifications. This system should not be used on water that
is microbiologically unsafe or with water of unknown quality
unless the water has been adequately disinfected before or
after traveling through the filtration system.
• Rated Capacity - 400 gallons
• Rated service flow - .5 GPM
• Maximum Rated Pressure - 100 PSI, Minimum 30 PSI
• Maximum Operating Temp. - 100°F, Minimum 33°F
changing the Filter:
Water conditions vary throughout the world, but changing the
water filter every 6 - 9 months normally will ensure the highest
possible water quality. Ice jams in the ice maker and/or
hollow ice cubes (partially frozen cubes with water inside),
may also be a sign that your water filter needs changing.
The Filter Status light will turn red after 400 gallons of water
has flowed through the ice and water dispenser. Also, if the filter
has been in a refrigerator that has not been in use for awhile
(during moving for example), change the filter before reinstalling
the refrigerator. The dispenser system will also operate without
filtration (with filter cartridge removed).
* White Westinghouse uses the name CrystalClear instead of PureSource, but they are the same filter.
AUtOmAtIC ICE & WAtER DISPENSER (CONtINUED)
to change filter:
It is not necessary to turn the water supply off to change the filter.
1 Open freezer door and leave open until filter change is
complete.
2 Turn OFF side mounted ice maker by raising wire signal
arm to the UP position. Turn OFF rear mounted ice maker
by pressing ON/OFF power switch to the "O" position.
3 Hold filter cup firmly, and unscrew towards left. (Some water
could leak out as you remove cup. This is normal.) Filter
cartridge should come down with cup. If cartridge remains in
housing, pull down gently, while twisting filter back and forth.
4 Rinse out cup under running water.
5 The large o-ring that seals the filter system fits in the
o-ring groove inside the cup. Should the o-ring fall out
during filter cartridge replacement, simply place it back
in the groove prior to screwing the cup back in place. If
the o-ring becomes damaged, you will need to order one
from the Electrolux Solutions Hotline.
6 Discard old filter cartridge.
7 Remove new filter cartridge from packaging. Place in cup.
The end with the small o-ring should be up, out of the cup.
8 Screw cup, with filter, back onto housing. Do Not Use
Wrench to Reinstall Cup. Filter cartridge will self-align
as cup is tightened. Be sure cup is completely tightened
with PureSource™ logo facing outward. Do Not tighten
Past Stop.
9 Turn ON side mounted ice maker by lowering wire signal
arm to the DOWN position. Turn ON rear mounted ice
maker by pressing ON/OFF power switch to the "I" position.
10 Check for leaks. Open refrigerator door. Wipe any water
droplets from the filter cup. Fill a glass with water. If
there is a leak, unscrew filter cup, and reinsert the filter
cartridge. Check placement of large O-ring. Reinstall filter
cup, making certain it is tightened completely.
11 to prime filter system and purge air from water line,
continue flushing the system for approximately 3 minutes
to assure that the purest water possible is stored in
the water tank. there will be noticeable spurts and
sputters as the system pushes air out through the
system and out the dispenser nozzle. this is normal.
ImPORtANt
Resetting the filter Status Light (some models)
After replacing the filter cartridge, it will be necessary to press
the Filter Status Reset button located on the ice and water
dispenser. This will reset the Filter Status light. Push the Reset
button until the green, red and amber lights flash (10-15
seconds). Please refer to the complete dispenser operating
instructions attached to the inside of the freezer door.
On models without a Filter status reset button, there is a
set of Reminder Stickers included in the envelope that the Use
& Care Manual came in. Choose a dated sticker that indicates
6 - 9 months (depending on your water quality and usage)
from the date of installation. Place the sticker on the front of
the filter cup to remind you when it is time to change the filter.
12