Datavideo MCU-100 Kullanıcı Kılavuzu - Sayfa 13

Kontrolör Datavideo MCU-100 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Datavideo MCU-100 18 sayfaları. Multi-camera controllers for panasonic cameras
Ayrıca Datavideo MCU-100 için: Hızlı Başlangıç Kılavuzu (2 sayfalar)

Sayfayı Yazdır

1. Connections and Controls

How to store selected camera set ups

How to copy settings set by MCU-100 from one camera to another

When MCU-100 is used to control more than one camera, it is possible to copy the settings set by the unit on

one camera to another via the Memory Stores functions of the unit.

Follow the following procedure to copy the settings set by the unit on camera to another.

1. Select the camera from which you want to copy the settings via the CAM 1 to CAM 4 buttons.

2. Press the LOAD SAVE button to start the copy process. The LOAD SAVE button will be back lit

orange and blinking.

3. Whilst the LOAD SAVE button is back lit orange and blinking select the camera to which you want to

copy the settings via the CAM 1 to CAM 4 buttons.

4. When the LOAD SAVE button is back lit green the copy process is then completed.

Note: This process does not work if either the selected source or destination camera is not

connected or is not powered on.

How to store / recall settings from internal memory MU-1, MU-2 or MU-3

The MCU-100 has dedicated internal memory to store the settings set by the unit on four cameras. This

internal memory can be accessed using the Memory Store functions.

Internally, the unit has three memory blocks indicated by the Memory Stores MU-1, MU-2 and MU-3. Each of

these blocks is divided into four segments, one segment for each camera. These are used to store the

settings for each camera accordingly.

Use this procedure to store the settings on a camera to the MCU-100 unit's internal memory.

1. Select the camera from which you want to copy the settings via the CAM 1 to CAM 4 buttons.

2. Press the LOAD SAVE button to start the copy process. The LOAD SAVE and the selected camera

button will be back lit orange and blinking.

3. Whilst these buttons are back lit orange and blinking select the memory block, MU-1, MU-2 or MU-3

button, to which you want to copy the settings.

4. When the MU-1, MU-2 or MU-3 button is back lit green and the copy process is then completed.

Use this procedure to recall a previously saved setting on the MU-1, MU-2 or MU-3 button to a camera.

1. Select the camera to which you want to copy the stored settings via the CAM 1 to CAM 4 buttons.

2. Select the memory block from which you want to copy the settings via the MU-1, MU-2 or MU-3

button.

3. Press the LOAD SAVE button to start the copy process. The LOAD SAVE and the selected camera

button will be back lit orange and blinking.

4. These buttons will be back lit green when copy process is completed.