Cooke Water Witch Kurulum Kılavuzu - Sayfa 5

Su Sistemi Cooke Water Witch için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Cooke Water Witch 6 sayfaları. A fully automatic pool and spa water levelling system
Ayrıca Cooke Water Witch için: Kurulum ve Ayarlama Kılavuzu (12 sayfalar)

Sayfayı Yazdır

INITIAL SETTING UP

Step by Step

Ensure the pool water level is set to the required level

1. Disconnect the power lead from the mains (power oﬀ)

2. Connect the sensor and solenoid plugs to control box

3. urn the water supply to the solenoid on

4. Remove control box cover and set dip switch to test mode as per Table 1 on Page 7

5. Replace control box cover, plug in power and turn on

6. Invert the sensor unit (sensor pointing skyward)

7. Switch the unit on and check the RUN & SENSE lights are ﬂashing every two seconds.

(refer Table 1 on Page 7 TEST MODE)

8. Lower sensor unit (Sensor pointing to ground). Now the RUN light should still ﬂash every

two seconds, and the FILL light should stay on continuously and water will ﬂow through the

solenoid.

Remember your pool water level must be correct to continue. Very slowly lower the

Sensor into the 40mm PVC Pipe until the water ﬂow stops and the RUN & SENSE lights ﬂash

every two seconds.

NOTE:

You may need to repeat steps 1- 6 until satisﬁed. Now attach the sensor to the PVC Pipe as

per Diagram 2 on Page 3. Switch power oﬀ and unplug the power cable. Remove control box

cover and set Dip switches as per Table 1 on Page 7 relative to the pool size. Put cover back

on, plug in and switch on power!

The unit is now set to the correct water level

with the new time delay settings.