4qd PRO-160 Series Kullanım Kılavuzu - Sayfa 5

Kontrolör 4qd PRO-160 Series için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. 4qd PRO-160 Series 16 sayfaları.
Ayrıca 4qd PRO-160 Series için: Kullanım Kılavuzu (16 sayfalar)

Sayfayı Yazdır

Thermistor input

Can be used to connect 1 or 2 sensors to monitor external temperatures.

Sensor X is connected to C and D, Sensor Y to A and B.

Once the sensors have been installed they must be enabled in the profile menu.

Radio Control Input and BEC

The Pro-160 will accept a standard hobbyist radio control servo signal directly

from a receiver. The receiver should be connected to pins B, C, and D. Pin D is

linked to pin A by Lk1, this can be removed if a 4 wire radio connection is

required.

The Pro-160 is pre-programmed to work with the majority of radio receivers.

Profiles 7 and 8 are configured for RC single ended and RC joystick use.

Depending on your radio system you may need to use the RC learn function to

properly match the Pro-160 to your receiver output.

PRO-160 V2.3/2 04/20

Sensors X and Y should be 4QD

part number SEN-TMP.

Page 5