Dateq Dymand Kullanıcı Kılavuzu - Sayfa 7

Amplifikatör Dateq Dymand için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Dateq Dymand 14 sayfaları.

Sayfayı Yazdır

Dateq DNA-Dymand Manual

Frontpanel description

The Dymand has two identical channels, channel 1 and 2. These channels have identical controls

(except for 'stereo-link'), therefore only one channel will be considered.

'ON'-Switch

Expander on

Expander threshold

Threshold

Ratio

10dB

Attack

Release

Meter IN/OUT

Key

Out

Chain

Locut

Monitor

Output

Stereo Link

This switch switches between 'bypass' and 'on'. When it illuminates

green it indicates the device is on. When it illuminates red it

indicates 'detection monitor' operation.

Switches the downward-expander proces on. When the proces is on

a green led illuminates.

Adjustment of the expander threshold level. This threshold is relative

to the compressor threshold (-40dB to 0dB). The expander has a

fixed ratio of 1:1.25.

Adjustment of the compressor threshold level (-20dB to +20dB)

Adjustment of the compressor ratio (1:1.5 to 1:20), 1:10 means

above threshold level at the input is 1dB at the output.

Adjustment of the process attacktime. The attacktime is the time the

compressor needs to follow the audiosignal that exceeds the

threshold level.

Adjustment of the process releasetime. The releasetime is the time

the compressor needs to recover from gainreduction after the

audiosignal has sunk below the thresholdlevel.

Switches the level-meter between input and output signal. When the

led illuminates red it indicates the meter is connected to the

outputsignal.

Switches the key-input to the detectioncircuit. This function could be

used for ducking.

Switches the outputsignal to the detectioncircuit. This function

creates another kind of compression; the (compressed) outputsignal

is used for detection.

Switches the sidechain-in signal to the detectioncircuit. The

sidechain function could be used for de-essing etc. Use the

sidechain input and output to connect, for example, an equaliser.

Switches a 80 Hz highpass-filter before the detectioncircuit. This

can be used to prevent pumping or breathing effects, or to create a

low-boost in voice-overs.

Switches the signal at the input of the detectioncircuit to the output.

This can be used to monitor the key-input or the sidechain-input.

When this function is activated the red led below the switch

illuminates, and the on switch illuminates red to indicate that

something other than the normal outputsignal is being heard.

Level adjustment for the outputsignal (-20dB to +20dB). This is used

to correct the output signal.

This switch activates the stereolink operation. When this function is

activated both the compression and the expansion process of both

channels are linked. All controls (output optional) are also linked.

Channel 1 will be the control-master. This feature saves adjustment

time when processing stereo-audio.

Operation