Agri-Fab 45-01011 Kullanıcı El Kitabı - Sayfa 5
Dış Mekan Arabası Agri-Fab 45-01011 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Agri-Fab 45-01011 12 sayfaları. Utility carts
Sayfayı Yazdır
9. Assemble the front panel over the end of the cart
using four 1/4" x 1/2" hex bolts and 1/4" hex nuts
as shown in figure 5. Leave two holes shown in
figure 5 empty in the bottom of the panel. Pull the
cart body halves together and tighten the two
bolts in the bottom of the front panel, then tighten
the bolt in each side.
At this time tighten the three bolts in the bottom of
the cart which were assembled in step 4.
LEAVE HOLES OPEN FOR
LATCH STAND BRACKET
1/4" HEX NUT
FIGURE 5
10. Assemble the wheel support to the cart using eight
5/16" x 3/4" truss head bolts and 5/16" hex nuts as
shown in figure 6. Heads of bolts go to the inside
of cart bed. Tighten.
WHEEL
SUPPORT
5/16" HEX
NUT
FIGURE 6
1/4" x 1/2"
HEX BOLTS
1/4" HEX NUT
5/16" x 3/4"
TRUSS HEAD BOLT
11. Turn the latch stand bracket so that the aligning tab
is at the rear (bottom) of the bracket. Assemble the
latch stand bracket to the cart using four 1/4" x 1/2"
hex bolts and 1/4" hex nuts. TIGHTEN. See figure 7.
LATCH STAND BRACKET
ALIGNING TAB
AT BOTTOM
1/4" HEX NUT
FIGURE 7
12. Assemble the two corner caps to the front corners of
the cart using four 1/4" x 1/2" hex bolts and 1/4" hex
nuts. Also assemble two 1/4" x 1/2" hex bolts and
1/4" hex nuts to the two rear corners of the cart.
TIGHTEN. See figure 8.
CORNER CAP
1/4" x 1/2"
HEX BOLT
FIGURE 8
5
1/4" x 1/2"
HEX BOLT
1/4" HEX NUT
1/4" HEX
NUT