Australian Direct ADCHG128 Kullanıcı Kılavuzu - Sayfa 9

Akü Şarj Cihazı Australian Direct ADCHG128 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Australian Direct ADCHG128 12 sayfaları. Smart battery charger 12v 8a, suitable for 12v normal lead acid, sealed, agm or gel batteries between 10-150ah, ip65

Sayfayı Yazdır

1. Operation

Care

Sometimes the battery may appear ﬂat, but this could simply be dirty or loose connections on your battery

terminals. It is important to maintain the leads on a regular basis. Do this by removing the leads from the

battery, clean the inside of each connector and terminal posts on the battery, reﬁt in there correct positions and

tighten ﬁrmly.

It is essential to keep the electrolyte level above the plates.

Note, however, that you should not overﬁll it, as the electrolyte is strongly acidic. When topping up do not use

tap water. Always use distilled or de-ionized water. It is important to keep the acid level up. If necessary have it

checked by your mechanic

Checking the condition of your battery

Using a hydrometer, which can be purchased, from most motor accessory stores, you can check the speciﬁc

gravity of the electrolyte in each cell. The hydrometer is use to suck up a quantity of ﬂuid from the cell. The

weighted ﬂoat inside the hydrometer will register the condition of that cell. Put the ﬂuid back into the cell after

testing, taking care not to splash the ﬂuid about.

TECHNICAL SPECIFICATIONS

For 12V Normal Lead Acid, Sealed, AGM or Gel or AGM Deep Batteries

Input:

220V – 240V ~ 50Hz Max. 150W,

Output:

14.4V, 2A DC (3A RMS)

14.4V, 8A DC (12A RMS)

14.7V, 8A DC (12A RMS)

13.8V, 5A DC (7.5A RMS)

ENVIRONMENTAL PROTECTION

Waste electrical products should not be disposed of with household waste.

Please recycle where facilities exist. Check with your local authority or retailer for recycling advice.

1.5A

IP65