AUSTRALIAN MONITOR SM12 Kullanım Kılavuzu - Sayfa 5
Müzik Mikseri AUSTRALIAN MONITOR SM12 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. AUSTRALIAN MONITOR SM12 12 sayfaları. Stereo mic/line mixing consoles pro series
Ayrıca AUSTRALIAN MONITOR SM12 için: Broşür (4 sayfalar), Kullanım Kılavuzu (9 sayfalar)
Sayfayı Yazdır
LINE INPUT SECTION
14
LINE L/R
These 6.35mm TRS jacks will accept
either balanced or unbalanced line
level signals. For mono operation use
left input only.
EQ SECTION
15
HIGH
This is a stereo shelf EQ filter that adjusts
treble frequency levels and will give up to
15dB of boost or cut at 12kHz. The centre
position will give a flat response.
16
MID
This stereo mid range EQ control adjusts
mid range frequencies and has a fixed
2 octave bandwidth at 2.5kHz. This
control will give up to 15dB of boost or
cut. The centre position will give a flat
response.
17
LOW
This low frequency stereo shelf EQ
control adjusts bass frequencies and will
give up to 15dB of boost or cut at 80Hz.
The centre position will give a flat
response.
SM12 & SM16 OPERATION MANUAL
AUXILIARY SECTION
18
PRE
Aux 1 is a mono split of the channel
input signal and is post EQ but pre the
channel fader.
19
POST
Aux 2 is a mono split of the channel
input signal and is post EQ and post
channel fader.
20
PAN
The channel pan control is used to
position the channel signal in the stereo
field. This differs from the mono channels
as this pan control will determine the level
of either the Left or Right buss that is sent
to the master mix. For example if the pan
control is turned fully clockwise, only the
Right signal path will be sent to the
master mix. If the Left input only is
connected (a mono signal) the pan control
will work as per the mono channels.
21
PEAK LED
This red LED illuminates when the
channel is going into overload (clip)
22
PFL
The Pre Fader Listen (PFL) switch is used
to monitor the input signal before the
channel fader. This can be switched to
either the headphone/local monitor
output or the master left/right outputs
(see master section)
23
LEVEL
This Channel output fader adjusts the
level of the channels signal before it
is sent to the Master output buss.
STEREO CHANNELS
14
15
16
17
18
19
20
21
22
23
PAGE 5