AUSTRALIAN MONITOR TX8000 Teknik Özellikler - Sayfa 2
Mikser AUSTRALIAN MONITOR TX8000 için çevrimiçi göz atın veya pdf Teknik Özellikler indirin. AUSTRALIAN MONITOR TX8000 2 sayfaları. 8 channel mic/line mixer
Ayrıca AUSTRALIAN MONITOR TX8000 için: Kullanım Kılavuzu (7 sayfalar), Broşür (2 sayfalar)
Sayfayı YazdırFrequency Response
40Hz - 15kHz (± 3dB)
Total Harmonic Distortion
Less than 0.05% @ 1kHz
Signal To Noise Ratio
-76dBV (all channels at centre position)
Tone Controls
Bass @ 100Hz, Boost +12dB, Cut -12dB; Treble @ 10kHz, Boost +9dB, Cut -9dB
Inputs
8 inputs, 6 of which are dual mic/line. The mic inputs are active balanced with
3 pin XLR female sockets (200-600 Ohms). Maximum Input Level is 300mV.
The line inputs are dual female RCAs (47K Ohms). Maximum Input Level is 10V.
The last two inputs are balanced mic only.
Input Sensitivity
Mic: 0.6mV @ 200 Ohms; Line: 150mV @ 47K Ohms
Phantom Power
18V DC
Outputs
Master Output, 3 pin XLR male socket. (1.5V @ 600 Ohms). Maximum Output
Level: +20dB. Mono Headphone Output, 1/4" socket (3.5V @ 600 Ohms).
Mono Tape Output, dual female RCA connectors. (700mV @ 10K Ohms)
Controls
Level Control per channel, Internal Trim Control per channel,
Recessed Treble and Bass Controls per channel, Master Level Control
Indicators
Power "on" LED, 7 segment LED meter
Power Sources
120VAC 60Hz 3 pin IEC connector; 24VDC
Power Consumption
7 vA
Dimensions/Weight
1.75" H x 19" W x 9.85" D (Chassis Dimensions Only). 6.6lb
ARCHITECTURAL AND ENGINEERING SPECIFICATIONS
The mixer shall have six dual microphone/line inputs and two dedicated microphone inputs. The microphone
inputs shall be active balanced and feature 3 pin female XLR sockets. The line inputs shall feature dual female
RCA sockets. Each channel shall include tamper resistant treble and bass controls. An internal trim pot shall
also be included for all channels.
The equalisation per channel shall provide 12dB cut or boost at 100Hz and 9dB cut or boost at 10kHz. The
master section shall include a master level control and a 7 segment output level LED meter. The master out-
put shall be a balanced 3 pin XLR male socket. The tape output shall feature dual RCA female sockets. A
1/4" mono headphone socket shall be included for monitoring. The mixer shall have facilities for a plug-in
dual level muting card, as well as a 4 tone generator card.
The mixer shall be of high quality, suitable for both live and commercial applications. It should have ample
headroom and a frequency response of no less then 40Hz - 15KHz (±3dB). Total Harmonic distortion shall be
no more than 0.05% at 1kHz. The S/N ratio shall be -76dBV or better. Phantom Power of no less than 18V
DC shall be available on all microphone inputs. An internal switch to disable the phantom power shall also
be included. The unit shall be packaged in a metal chassis suitable for desk or rack mounting.
The mixer shall be an Australian Monitor Installation Series model TX8000.
UL APPROVED
AUSTRALIAN MONITOR AUDIO INC.
PO Box 3126, Lynnwood, WA 98046 • Voice: 425-673-5175 • Fax: 425-673-7825
• Website: www.australianmonitor.com • Email: [email protected]