Agri-Fab 45-03086 Kullanıcı El Kitabı - Sayfa 12

Tiller Agri-Fab 45-03086 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Agri-Fab 45-03086 16 sayfaları. Universal tow behind tiller

Sayfayı Yazdır

Follow the instructions in the "Service & Storage" section of the

Engine Manual when performing any work on the Engine.

No gasoline in fuel tank

Choke not set properly

Throttle control not set properly

Choked improperly, flooded engine

Loose spark plug wire

Spark plug dirty or improper gap

Water in gasoline or old fuel

Engine overloaded

Partially plugged air cleaner

Spark plug dirty, improper gap or wrong type

Low oil level or dirty oil

Partially plugged muffler

ExCESSIVE BOUNCE AND DIFFICULT HANDLING

Wheels and depth stake incorrectly adjusted

Ground too dry and hard

ENGiNE RUNS WELL BUT TiLLER WON'T MOvE

Tine control not engaged

V-belt off of pulleys

ENGiNE RUNS WELL BUT LABORS WhEN TiLLiNG

Throttle control not properly adjusted

TROUBLEShOOTiNG

PROBLEM

Probable Cause

WiLL NOT START OR hARD TO START

Dirty air cleaner

Clogged fuel tank

ENGINE MISSES OR LACkS POWER

Dirty air screen

Oil in gasoline

Clogged fuel tank

Poor compression

ENGiNE OvERhEATS

Dirty air screen

Dirty engine

SOIL BALLS UP OR CLUMPS

Ground too wet

Tilling too deep

Possible Remedy

Fill tank with gasoline

Place choke control in choke position

Place throttle control in fast position

Move choke control to run position, place throttle control in fast

position and pull starter several times to clear out gas

Remove to inspect, replace if dirty

Make sure spark plug wire is seated properly on spark plug

Replace spark plug and adjust gap

Drain fuel tank and carburetor, use fresh fuel and replace spark plug

Remove and clean

Set depth stake and wheels for shallower tilling

Remove and clean or replace

Clean air screen

Replace spark plug and adjust gap

Drain and refill tank and carburetor

Remove and clean

Major engine overhaul

Add or change oil

Clean air screen

Clean cylinder fins air screen and muffler area

Remove and clean muffler

Adjust wheels and depth stake

Moisten ground or wait for more favorable soil conditions

Wait for more favorable soil conditions

Engage tine control

Check v-belt

Adjust depth stake

Check throttle control setting