AUSTRALIAN MONITOR IMGC450 Kurulum ve Kullanım Kılavuzu - Sayfa 4

Mikrofon AUSTRALIAN MONITOR IMGC450 için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. AUSTRALIAN MONITOR IMGC450 8 sayfaları. Gooseneck microphone
Ayrıca AUSTRALIAN MONITOR IMGC450 için: Kullanım Kılavuzu (4 sayfalar)

Sayfayı Yazdır

INSTALLING SHOCK MOUNT &

IMGC450 MICROPHONE

The shock mount is designed to be flush-mounted and

provides isolation to reduce room-rumble and mechanical

noises from being amplified.

Installing the Shock Mount

Choose a suitable flat surface to install the shock

mount.

Using a hole saw cut a 51mm (2inch) diameter

hole through the mounting surface

Slide the shock mount into the freshly cut hole

and mark the location of the three screw holes

using a marker or punch.

Using a 3.0mm drill pre-drill three pilot holes.

Insert the shock mount into the hole again and

fasten down the shock mount with the 3 screws

provided.

Installing IMGC450 into the Shock Mount

To install the IMGC450 into the Shock Mount

unscrew the bottom plastic screw collar.

Slide the IMGC450 body into the Shock Mount.

Re-install the bottom plastic screw collar until snug.

Be careful not to cross thread or crack the plastic

screw collar.

Insert a female 3-pin XLR connector into the

microphone base.

Phantom power is required for the IMGC450

to operate.

To avoid possible loudspeaker damage ensure

the PA system is muted first before you enable

phantom power.

IMGC450 INSTALLATION AND OPERATION MANUAL