4RF Aprisa LTE Hızlı Başlangıç Kılavuzu - Sayfa 4

Kablosuz Yönlendirici 4RF Aprisa LTE için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. 4RF Aprisa LTE 7 sayfaları. Lte cellular router
Ayrıca 4RF Aprisa LTE için: Hızlı Başlangıç Kılavuzu (7 sayfalar)

Sayfayı Yazdır
4RF Aprisa LTE Hızlı Başlangıç Kılavuzu
Page 4

3. Set up and apply power to the Aprisa LTE

A valid SIM provided by your local wireless carrier e.g. Verizon, AT&T, EE, and
Vodafone is required for connectivity.
The LTE can accommodate two standard Micro SIMs (12 x 15mm) which fit into
the product rear under the SIM cards cover plate.
Contact your carrier for details about selecting a data plan and about the
process for activating your SIM.
Install an activated SIM in the Aprisa LTE:
1.
Ensure the power to the Aprisa LTE is turned off.
2.
Unscrew the two screws on the SIM cards cover plate.
3.
Fit the SIM to 'SIM 1 Slot' slot notch-end first with metal contacts facing
up.
Attach either separate antennas for LTE, GNSS and Wi-Fi or a single combination
4.
Refit the SIM card cover plate and fasten the two screws.
antenna to the appropriate QMA connectors on the Aprisa LTE.
The Aprisa LTE is operated from a DC source of voltage between +9 VDC and +32
VDC (negative earth) and consumes up to 15 watts. External power supplies are
available from 4RF as accessories (see the Aprisa LTE User Manual).
The Aprisa LTE power connector is a Molex Micro-Fit 3.0 4 pin male connector.
The power supply input connects to pin 1 +ve and pin 2 -ve. A 1 metre power
cable fitted with 4 pin Molex Micro-Fit 3.0 female connector and wire ended is
supplied in the box with each Aprisa LTE.
The Molex Micro-Fit 3.0 4 pin connector clips into the Aprisa LTE socket. It also
has a locking plate and screw (supplied with the Aprisa LTE) that enables the
connector to be secured to the Aprisa LTE with a screw.
Note: The Aprisa LTE internal fuses will blow if the connected power supply is
over voltage or the polarity is reversed. If this happens, the fuse(s) will need to
be replaced. Spare fuses can be ordered from 4RF (see the 'Spare Fuses' section
of the Aprisa LTE User Manual).
Turn your power source on. The Aprisa LTE OK and AUX LEDs will flash orange while the router is booting up.
The Aprisa LTE OK LED will light green when the router is ready to operate.
For vehicle installation, the Aprisa LTE power connector pin 3 is used as an ignition sense line and should be connected to a
source of +12 or +24 volts that comes on when the vehicle is running. No connection is required for stationary applications.