CookTek MW3500G Kurulum ve Çalıştırma Kullanım Kılavuzu - Sayfa 10

Setüstü Ocak CookTek MW3500G için çevrimiçi göz atın veya pdf Kurulum ve Çalıştırma Kullanım Kılavuzu indirin. CookTek MW3500G 12 sayfaları.

Sayfayı Yazdır
GREASE FILTER MAINTENANCE
This unit comes equipped with a grease filter(s) to protect the electronics from
contaminants.
Grease filter cleaning procedures:
Frequency
● Grease filter(s) should be removed and cleaned every two weeks. More
frequent cleaning may be necessary if they appear clogged and/or operate in
heavy grease laden environments.
Procedure
● Slide filter(s) outof the track on the bottom of the unit.
● Back flush with hot water to remoe dirt and grease.
● Shake remaining water out and let stand until completely dry.
● Reinstall filter(s) ensuring the arrow on the edge of the filter(s) is ponting into
the unit.
● NOTE: filters are also dishwasher safe.
Caution
● Do not operate the unit without the grease filter(s) installed.
● If the unit displays and error code of "E4" - the overheat error - this may indicate
a clogged filter. Follow the procedure above and let the unit cool down before
resuming operation (turn off for approximately 5 minutes).
9

ERROR CODES

In the event of a possible malfunction, your CookTek wok will display an Error Code
on the LCD Information Center and the unit will beep the numer of times indicated
by the error. Please consult the following table when encountering an Error code.
To reset the error conditions, remove the pan from the unit and press the POWER
button or unplug the unit.
Error Error Cause
Displayed Message
Temperature sensor failed.
1
Shorted RTD
Call dealer.
Temperature sensor failed.
2
Opened RTD
Call dealer.
Over current
3
Incompatible pan
(peak)
Overheating. Check airflow.
4
Open TCO
Unplug, let cool.
Air flow
Air flow blocked. Clean
5
blocked
grease filter.
High line
Input voltage too high.
6
voltage
Check mains voltage.
7
Harware failure Call dealer for service.
Zero cross
8
Call dealer for service.
failure
9
Clock corrupt
Reset clock.
Pan RTD
Pan temperature sensor
10
failure
failed.
Tag
Reposition pan & cycle
11
communication
power.
failure
RFID reader
12
Call dealer for service
failure
User
14
interface
Cycle power.
error
16
Critical error
Call dealer for service.
Troubleshooting
Service required
Remove any pans from wok
surface and let unit cool. Then
turn unit off, then on. If problem
was temperature related, the unit
will return to normal operation.
Otherwise, service is required.
Try different cookware. Service
may be required.
Check airflow. Clear air vents.
Listen for fan operation.
Check to ensure the grease filter
is clean and dry. Make certain
there are no foreign objects
blocking air flow. Check the air
filter to ensure that the arrow on
the filter is pointing up.
To reset, unplug unit, wait 5
seconds, and plug in again. If
problem persists, have an
electrician monitor the line
voltage.
Service required. Turn unit off,
then on. Plug unit into outlet on
different circuit breaker. If
problem persists, service is
required.
Reset clock.
RFID pan needs repair. Service
needed for pan.
Ensure the RFID tag on the pan is
properly located.
Service required.
Service required.
Service required.
Manual Apogee Wok 10336_A USINTL
14