Bendcart BC-100 Montaj Talimatları - Sayfa 3

Dış Mekan Arabası Bendcart BC-100 için çevrimiçi göz atın veya pdf Montaj Talimatları indirin. Bendcart BC-100 5 sayfaları.

-The appropriate follow bar should be installed so that one end is resting on the

roller and the other end is resting on the follow bar support with the follow bar

ears outward. (NOTE: The bender may have to be slid back if the follow bar

doesn't rest on both the roller and the follow bar support. The bender supports

are designed so that the bender can be slid either forward or back as necessary.)

-Set the pump in the pump tray and connect the hose to the ram. You may find

it useful to purchase 90 deg hydraulic fittings for the pump and cylinder.

(NOTE: the pump should be secured to the pump support with bungee cords,

wire or other means.)

-Set the appropriate shoe onto the follow bar and connect it to the ram yoke

(NOTE: this may be made easier by pumping the ram down several inches.)

-Install the saddle and the operation is complete.

BENDING CONDUIT

-Slide conduit onto follow bar and under the conduit support wheel

-Install the saddle (NOTE: for a one man operation you may find it easier to pull

the shoe back and up with a wire, bungee cord , or some other means so that the

saddle is touching the front of the follow bar. Don't forget to remove the wire or

cord before bending!!!!!)

-Start bend

-Adjust the follow bar support adjustment handle so that the conduit behind the

shoe is level.

-Bend conduit. For accurate bends using a protractor, readjust the conduit for

level when you are within a few degrees of the desired bend.

WARNING:

saddle pin getting caught under the Bendcart crossbar when making 90 deg

bends. This is more of a problem on smaller conduits as the pin can extend thru

the saddle several inches. Be sure that the conduit is centered in the bender and is

parallel to the Bendcart when starting the bend.

MISCELLANEOUS

-See page 3 for the positions of the pump tray when not in use.

-The unit can be made reasonably secure by threading a heavy chain through

the saddles, through the holes of the shoe, through the pump handle and around

the bender.

TIPS

-Use a large C-clamp or welders vise grip to clamp the saddle to the conduit, this

will prevent the shoe from sliding down the bend when pressure is released to

check spring back.

-To eliminate dogleg on segment bends make a line lengthwise on the conduit (or

use the seam mark). Make a mark on the face of the shoe. Be sure that the lengthwise

line matches the mark on the shoe for each bend.

If the conduit is not properly aligned there is a possibility of the

pg. 2