BENDIX AD-2 Manuel - Sayfa 9

Nem Alıcı BENDIX AD-2 için çevrimiçi göz atın veya pdf Manuel indirin. BENDIX AD-2 16 sayfaları.
Ayrıca BENDIX AD-2 için: Hizmet Verileri (16 sayfalar)

Sayfayı Yazdır

4. Insert one of the perforated plates into the cartridge,

cloth side up, and tap it firmly to the bottom. (Cloth

always faces desiccant material.) (See Figure 8)

FIGURE 11

5. Slide oil separator filter over the cartridge bolt with the

gasket surface next to the shell. (See Figure 9)

6. Install the bolt with the oil separator into the bottom of

the shell and through center hole of the perforated plate

in the bottom of the shell. (See Figure 10)

7. Pour the entire package of desiccant material into the

shell, making sure none is lost. Handle carefully so

that the bolt does not fall out. (See Figure 11)

8. Level the desiccant material and install second

perforated plate cloth side down. (Make sure the

shoulder of the bolt is centered, and extends slightly

above the top of the perforated plate.) (See Figure 12)

NOTE: If the shoulder of the bolt does not extend above

the perforated plate tap the side of the desiccant

container.

9. Set the conical spring on top of the perforated plate

(large diameter down - small diameter up.)

10. Place the spring retainer on top of the spring (See Figure

13)

11. Install the previously rebuilt desiccant sealing plate on

the cartridge bolt so that the ball check retaining clip is

in view.

12. Using the lock nut draw the assembly together to

approximately half of the spring's free height. While

slowly turning the cartridge, tap the side of the shell

with a plastic mallet (See Figure 14). This allows the

desiccant material to settle properly into place. Continue

to tighten the nut, making sure all items are properly

aligned. Tighten nut firmly using an 11/16" socket or

box wrench. (See Figures 15-1, 15-2)

FIGURE 12

FIGURE 13