dymax 39381 Kullanım Kılavuzu - Sayfa 10

Endüstriyel Ekipmanlar dymax 39381 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. dymax 39381 16 sayfaları. Uv light-curing conveyors – 18" and 25"

Sayfayı Yazdır

SYSTEM OPERATION

1. Turn on the main power to the conveyor (Figure 11).

2. Press "START" on the Conveyor Speed Controller (Figure 12). Set the Belt speed by pressing and holding the

up arrow or down arrow. Belt speed can be adjusted from 1 to 50 fpm.

3. Turn Power Supply's main power on. This is done by turning the red knob on the Power Supply Front Panel

(Figure 13) to the "ON" position.

Figure 11. Main Power Controls

4. Select "RUN UV" on the Touch Screen Interface (Figure 14).

5. Turn on the control power to the UV by pushing the green "ON" Button located on the Power Supply Front

Panel (Figure 13).

6. Select "LAMP ON 400W" on the Touch Screen Interface to start the UV Lamp (Figure 15). "LAMP

WARMING" will appear at the bottom of the Touch Screen. Once the UV Lamp is ready, "LAMP ON 400W"

will be displayed.

NOTE:

The UV Lamp must always be started at 400 W. After the UV Lamp has warmed up, a lower power

may be selected if desired.

7. Adjust the height of the UV Lamp as desired by turning the UV Irradiator's Hand Crank (Figure 16). The

height of the UV Lamp above the Belt is shown by a Scale mounted on the top of the conveyor so that

adjustments may be performed without the operator looking into the Curing Chamber.

Figure 14. Select "RUN UV" on

the Touch Screen Interface.

8. After the Power Supply is shut off there is a delay before the UV Blower shuts off. Do not shut off the power

to the main machine before the UV Blower shuts off.

Dymax WIDECURE UV Conveyor

Figure 12. Conveyor Speed

Controller

Figure 15. Select "LAMP ON 400W"

on the Touch Screen Interface.

Figure 13. Power Supply Front Panel.

Figure 16. UV Lamp's Hand Crank & Scale