Active Living BP-1307 Kullanıcı El Kitabı - Sayfa 3
Kan Basıncı Monitörü Active Living BP-1307 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Active Living BP-1307 8 sayfaları. Upper arm blood pressure monitor
Sayfayı Yazdır
Important Testing Guidelines
1.
Avoid eating, exercising, and bathing for 30 minutes prior to testing.
2.
Sit in a calm environment for at least 5 minutes prior to testing.
3. Do not stand while testing. Sit in a relaxed position while keeping your arm level with your
heart.
4. Avoid speaking or moving body parts while testing.
5. While testing, avoid strong electromagnetic interference such as microwave ovens and mobile
phones.
6. Wait 3 minutes or longer before re-testing.
7
. Try to measure your blood pressure at the same time each day for consistency.
8
. Test comparisons should only be made when monitor is used on the same arm, in the
same position, and at the same time of day.
9. This blood pressure monitor is not recommended for people with severe arrhythmia.
10. Do not use this blood pressure monitor if the device is damaged.
Unit Operation
Battery Installation
Slide battery cover off as indicated by arrow.
Install 4 new AA alkaline batteries according to correct +/- polarity.
Close battery cover.
AC Adapter jack is on the back side of the monitor. Medical AC adapter(DC 6.0 V,600mA)
can be used with the device (recommended, not provided). The adapter connect pin should
be positive inside and negtive outside with a 2.1mm coaxial joint.
Do not use any other type of AC adapter as it may damage the unit.
AC Adapter Jack
7
Quick Start
1. Install batteries
. (See Figure A )
2. Insert cuff air plug into the left side of monitor unit. (See Figure B)
Figure A
3. Remove thick clothing from the arm area.
4. Rest for several minutes prior to testing. Sit down in a quiet place, preferably at a desk
or table, with your arm resting on a firm surface and your feet flat on the floor.
(See Figure C )
Figure C
5. Apply cuff to your left arm and keep level with your heart. Bottom of cuff should be
placed approximately 1-2cm (0.4-0.8'') above elbow joint. (See Figures D&E)
Figure D
6. Press
" START/STOP "
Button to start testing.
9
Unit Operation
System Settings
With power off, press "SET" button to activate System Settings. The Memory Group icon
flashes.
1. Select Memory Group
While in the System Setting mode, you may accumulate test results into 2 different
groups. This allows multiple users to save individual test results (up to 60 memories
per group.) Press " M " button to choose a group setting. Test results will
automatically store in each selected group.
2. Time/Date setting
Press"SET" button again to set the Time/Date mode. Set the year first by adjusting
the "M" button.
Press"SET" button again to confirm current month. Continue setting the date, hour
and minute in the same way. Every time the "SET" button is pressed, it will lock
in your selection and continue in succession ( month,date,hour, minute)
Figure B
Figure E
/
8
10