AFF 3052A Kullanım Kılavuzu - Sayfa 3

Jacks AFF 3052A için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. AFF 3052A 12 sayfaları. 1,100 lbs air assist 2 stage transmission jack

ASSEMBLY

1. Refer to the parts diagrams for identification, location, and position of parts.

2. Take out all parts from box.

3. Secure caster with foot brake (47) and regular caster (5) onto the leg base (43) by using nut (44,) lock

washer (45,) and washer (46.) Secure the other 2 casters on the opposite leg base using the same

hardware. Be sure that each caster with foot brake is placed on each leg directly opposite of each other.

4. Place the hydraulic power (30) unit in an upright position. Secure the leg base (43) to the pump by using

washer (48), lock washer (49) and bolt (50.)

5. To assemble the saddle (51) first loosen and remove bolt (S19) and place saddle on the second piston rod

(6.) Tighten bolt (S19) to secure.

6. Install the air disconnect of your choice in the air valve. Make sure to apply pipe tape to seal off the

threads and prevent any tape from entering the air system.

Air Purging Instructions

If the jack does not raise the load or raises very slowly after activating the pump pedal there may be air

trapped in the primary ram and hydraulic system.

Step 3

Operate the foot pedal and lift the

adapter to the max height. Loosen

screw (#16.) Operate the foot

pedal 4-5 times to eliminate any

existing air in piston. Tighten

screw.

Step 1

Loosen bleeder screw

counterclockwise

Step 2

Take off the M6x30 bolt. Loosen

M6x5 screw by half turn with 3mm

allen wrench. Operate the foot

pedal 2-3 times until oil escapes

from hole without air bubbles.

Keep pedal depressed and tighten

both screw and bolt.

Page 3