Benedini TBS Micro V2.0 Manuel - Sayfa 2
Kayıt Ekipmanları Benedini TBS Micro V2.0 için çevrimiçi göz atın veya pdf Manuel indirin. Benedini TBS Micro V2.0 9 sayfaları.
Sayfayı Yazdır
1. Introduction
The digital sound unit TBS Micro can be used for any kind of RC-Model. It is connected directly
to the receiver outputs, in parallel to the speedcontroller. This ensures the ability to use the sound
unit in combination with brushless motors.
A 1W NF amplifier is already included.
Due to the dimensions and the weight of the unit, it is highly suitable for models in 1/87 scale and
electric planes.
The electrical connections to the receiver can be done by common servo cables, plugged into
sockets mounted on the PCB area at the left side of the TBS Micro. The power supply is provided
by the receiver.
Note the maximum supply voltage of 5V!
In space critical applications, the PCB area for the sockets can be cut. In this case the servo
signals and the power supply must be connected to the copper spots beside the socket area. Good
solder skills are necessary!
The TBS Micro is delivered with unmounted sockets for the receiver cables. This ensures the
flexibility to use sockets or soldering the servo wires directly at the PCB or cutting the PCB area
off.
External amplifiers are available.
The volume can be adjusted remotely via the RC-transmitter or manually at the amplifier.
A optional programming adaptor is available to configure the sound unit at a common PC or to
install new sounds on it.
The free of charge configuration software TBS Flash is available at www.benedini.de, as well as
soundlibraries
free of charge
The soundunit can be controlled by a separate proportional channel or in "Autostart" mode.
Possible control modes:
12 position encoder
●
3 position switch for direct sound selection (only two sounds selectable)
●
3 position switch for indirect sound selection (all sounds selectable)
●
Autostart
●
The desired control mode can be selected by the programing adapter or manually.
Soundmodule TBS Micro V2.0
.
Page:2