Benedini TBS Mini Manuel - Sayfa 6

Kayıt Ekipmanları Benedini TBS Mini için çevrimiçi göz atın veya pdf Manuel indirin. Benedini TBS Mini 11 sayfaları. Digital multifunctional rc-soundunit
Ayrıca Benedini TBS Mini için: Teknik Veri Kılavuzu (11 sayfalar), Manuel (11 sayfalar)

Sayfayı Yazdır
Benedini TBS Mini Manuel
3.1.1. Push button encoder
A simple resistor array combined with some push buttons can be also used to control the
soundunit. This is only a suggestion and needs to be build by your own:
R1
P1
390
5k
R12
S1
5k6
You should check the operation by a common servo. Adjust the min. and max. travel range with
the potentiometers P1 and P2 in comparison to the travel at a common joystick channel(f.e.Ch1).
The installation of this circuit in your transmitter is on your own risk
Proper functionality is not guaranteed at ALL transmitter brands / types

3.1.2. Teaching the sound unit for encoder control

1) Power transmitter and receiver. LED blinks fast -> normal mode
Bring all joysticks to neutral position. Model must not move.
2) Press the TEACH. button until one beep occurs -> LED cont. lit.
At this moment all neutral / idle positions are stored.
3) Move throttle stick to your desired acceleration point (throttle stick position where
engine idle sound changes to moving sound) and push the button of the encoder.
-> A short sequence of acceleration is played
4) Move throttle stick to full speed and push the encoder button again
A short sequence of full speed is played.
5) Bring the encoder rotary switch to its first position and push the encoder button
-> Engine start/stop is stored to this position
Hint: The rotary switch has no mechanical limits. You can define any position as the
"first" one.
6) Bring the encoder rotary switch to the next position, wait about 2s and push the
encoder button again.
-> Reeving up the engine is stored to this position
7) Repeat step 6 until all 12 rotary switch positions are stored
8) After teaching all positions the sound unit beeps 3x and is back in normal operation
mode.
Hint:
If you are using the resistor network shown above instead of the encoder, each rotary switch
position is represented by one of the push buttons.
TBS Mini
R2
R3
R4
R5
390
390
390
390
S2
S3
S4
S5
www.benedini.de
R6
R7
R8
R9
390
390
390
820
S6
S7
S8
S9
ST1
Zum S ender
R10
R11
P2
390
390
5k
S10
S11
S12
R13
5k6
Page 6 of 11