Dymo M1011 Kullanıcı Kılavuzu - Sayfa 12

Etiket makinesi Dymo M1011 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Dymo M1011 14 sayfaları. Rhino
Ayrıca Dymo M1011 için: Kullanıcı Kılavuzu (16 sayfalar), Kullanıcı Kılavuzu (16 sayfalar)

Sayfayı Yazdır

Punching Holes in Non-Adhesive Labels

You can choose to punch one or two holes in non-adhesive labels so

that the labels can be attached using screws, nails, rivets, and metal

or plastic wires or ties. You can also punch a cable tie slot in one or

both ends of the label.

To punch a hole

1. Insert one end of the cut label into the hole punch slot (L).

2. Lift the cutting handle (I) to the vertical position to punch a hole.

To punch a cable tie slot

1. Insert one end of the cut label into the cable tie slot (K) with the

letters facing down. The letters must face down to ensure the

bridge of the slot is on the same side of the label as the

characters.

Make sure to allow enough room for the tie-buckle before

and/or after the letters. A cable tie slot positioned on top of the

characters or a punched hole may cause the tape to jam.

2. Lift the cutting handle (I) to the vertical position to punch the slot.