Dymo RhinoPRO 5000 Kullanıcı Kılavuzu - Sayfa 8
Etiket makinesi Dymo RhinoPRO 5000 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Dymo RhinoPRO 5000 14 sayfaları. User guide
Ayrıca Dymo RhinoPRO 5000 için: Hızlı Referans (2 sayfalar), Teknik Özellikler (2 sayfalar), Kullanıcı Kılavuzu (13 sayfalar)
Sayfayı Yazdır
Printing Fixed Length Labels
Normally, the length of the label is determined by
the length of the text entered. However, you may
wish to make a label for a specific purpose that is a
fixed length regardless of the length of the text.
You can specify a fixed length for a label in 0.5 mm
(0.2") increments between 10 mm (0.4") and
999.9 mm (40.0"). The preset fixed length is 40 mm
(1.5"). Any change you make to the fixed length
setting remains in effect until you change it.
To set the label length
1. Press
.
2. Use the arrow keys to increase or decrease the
label length.
3. Press
.
If multiple copies of a fixed-length label are
printed, cut marks are printed between each label.
See Figure 9.
Cut Marks
Figure 9
Printing Patch Panel Labels
Patch panel mode allows you to label a row of ports
on a patch panel. You can select the distance
between ports and serialize the label, or you can
enter different label text for each port manually, and
then print. The result is a long label with evenly
spaced text for each port.
01
02
03
04
�
8
8
Manual_RhinoPRO5000_WEU.indd 8
To print a patch panel label using serialization
1. Press
.
2. Enter the distance between each port and
press
.
The default is 12 mm (0.5") and the value can be
set in increments of 0.1 mm (0.005").
3. Enter the text for the first position on the label.
4. Follow the directions in Serializing Your Labels
on page 10 to serialize the text that will print on
the label.
To print a patch panel label manually
1. Press
.
2. Enter the distance between each port and
press
.
The default is 12 mm (0.5") and the value can be
set in increments of 0.1 mm (0.005").
3. Enter the text for the current position on the label
and press
G
.
4. Repeat step 3 until all port labels are printed.
To clear the previous label text, press
5. Press +
to feed the tape after the last port
and then cut the label using the Cutter lever.
Printing Module Marking Labels
Module marking allows
you to create a label for
and electrical module
rack that has a varying
number of modules of
different sizes placed
on one DIN rail.
To print a module marking label
1. Press
.
2. Enter the size of a single modular component
and press
.
+
0
.
X=1
ROOM1
HEATING
ROOM1 LIGHT
23-07-2004 10:51:34