Dymo LabelWriter DUO Hızlı Başlangıç Kılavuzu - Sayfa 7

Yazıcı Dymo LabelWriter DUO için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Dymo LabelWriter DUO 14 sayfaları. Dymo labelwriter printer quick start
Ayrıca Dymo LabelWriter DUO için: Hızlı Başlangıç Kılavuzu (12 sayfalar), Genel Bakış (2 sayfalar), Kullanıcı Kılavuzu (19 sayfalar), Hızlı Başlangıç Kılavuzu (6 sayfalar), Hızlı Başlangıç Kılavuzu (8 sayfalar)

4. Loading Labels

The LabelWriter Duo printer prints two types of labels: die-cut paper labels (such

as Address or DYMO Stamps

To load die-cut labels

Press the form-feed button to eject the labels that

protected the printer during shipment.

Open the top cover and remove any packing

material inside the label compartment.

Remove the label spool from inside the cover.

Hold the spool spindle in your left hand and place the

label roll on the spindle so that the labels feed from

underneath and the left edge of the label roll is flush

against the side of the spool. See Figure 7.

Place the spool guide onto the right side of the spool

and press the guide tightly against the side of the

label roll, leaving no gap between the roll and the spool. See Figure 8.

The label roll must fit snugly against both sides of the

NOTE

label spool, with no gaps, to avoid drifting as the labels feed

through the printer.

Insert the label spool into the slot in the printer cover with

the labels extending from underneath the roll. See Figure 9.

™

Postage labels) and D1 label cassettes.

Spool

guide

spindle

Figure 7

Figure 8

Figure 9