Benelec 09211B Kullanıcı Kılavuzu

Güç Kaynağı Benelec 09211B için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Benelec 09211B 6 sayfaları. Linear 8 / 10 amp 13.8 volt power supply with battery management

Sayfayı Yazdır
USER MANUAL
LINEAR 8 / 10 AMP 13.8 VOLT POWER SUPPLY
WITH BATTERY MANAGEMENT
Power Supply (Front)
Power Supply (Back)
The power supply is designed to supply 13.8 Volts nominal
D.C. at 7.5 Amps nominal (09210FB /APN6153B) or 10 Amps
nominal (09211FB) from a 230 Volts 50 Hertz mains source
to power radio communication equipment with an RF
power output of up to 25W. A battery charger circuit is
included to allow the charging of a 12 Ah SLA or AGM
battery only, along with a battery manager to disconnect
the battery when the voltage falls below 10.5 Volts, to stop
deep discharge. It uses a thermostatically controlled
internal fan to assist cooling.
This supply is presented as a black powder coated laser cut
metal case, and also incorporates Nut-Serts in the side of
the device for the inclusion in an external housing. The
supply incorporates a socket to power an external housing
fan.
GENERAL SAFETY SUMMARY
To ensure safe operation of the power supply the following
instructions must be followed:
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not
play with the appliance.
Benelec Pty Ltd. 17 Byrnes St, Botany NSW 2019, Australia,
09210FB (APN6153B)/ 09211B
PART NO:
Use Only an Approved Power Lead
The IEC power lead supplied with the power supply is
certified to meet Australian Standards. Using a different
lead could create a shock or fire hazard.
Do Not Operate Without Covers
To avoid electric shock or fire hazard, do not operate this
product with covers or panels removed.
Use Proper Fuse
To avoid fire hazard, use only the fuse type and rating
specified for this product. Mains Fuse 4AT M205, Battery
Fuse 10A Red Automotive Blade Fuse.
Do Not Operate in Wet/Damp Conditions
To avoid electric shock, do not operate this product in wet
or damp conditions.
Do Not Operate in Explosive Atmosphere
To avoid injury or fire hazard, do not operate this product in
an explosive atmosphere.
Disconnect The Supply Before Making or Breaking The
Connections To The Battery
To avoid damage to the supply or external equipment make
sure the supply is turned off and the battery is isolated
before making or breaking any external connections to the
Power Supply.
Provide Proper Ventilation
To prevent product overheating and switching off, provide
proper ventilation.
Do Not Operate With Suspected Failures
If you suspect this product is defective, have it inspected by
qualified service personnel.
Use Only Specified Battery Type
Use only SLA or AGM batteries with an initial charge current
rating of at least 1.5 A.
Do Not Use Non-Rechargeable Batteries
Could result in fire or explosion.
Radio Power Lead Must Be Fused
Ensure the the radio's power lead is fitted with the radio
manufacturer's recommended fuse.
BENELEC.COM.AU
+61-2-8397-3333,
+61-2-9700-1231,
Page 1 of 6
2023-04-11