Gadgetree 8045736 Kullanım Talimatları - Sayfa 2

Otomobil Aksesuarları Gadgetree 8045736 için çevrimiçi göz atın veya pdf Kullanım Talimatları indirin. Gadgetree 8045736 3 sayfaları. Head-up dashboard display

Sayfayı Yazdır

The FUNCTION BUTTON can be pushed up, down and inwards. It is the primary control for the HUD unit:

1. Press the button to change the function being displayed. Each press will show you engine temperature, battery voltage or speed.

2. The HUD is preset with alarm warnings turned ON and will sound when surpassing a preset limit. To turn the alarms off, press downward and hold the

button for 5 seconds. To turn the alarms back on, press downward and hold the button for 5 seconds.

SETTINGS & ADJUSTMENTS

Sometimes it will be necessary to adjust the settings on the HUD unit to match the readings found on your car's dashboard. If this is needed please fol-

low these steps:

1. Press and hold the FUNCTION BUTTON until it reaches setting mode (approx. 5 seconds).

2. Press again with a short press to bring up the settings menu. See chart below to help navigate to the desired setting.

3. When complete, press and hold the FUNCTION BUTTON for 5 seconds to save your settings.

Function

Adjustment

range

Speed

50-150

Engine RPM

50-150

RPM Alarm

10-75

Speeding Alarm

30-500

Brightness

0-2

Speed unit

1-2

Water

1-2

temperature unit

Auto off

10-900

TROUBLE SHOOTING

1. Screen is blank - Ensure the HUD power is on and the OBD II connecting line is securely connected. Also, try re-starting the car.

2. Power is on but screen only shows battery voltage and/or turns off after 30 seconds - Please ensure your car supports OBD II by verifying it has a

certification sticker or check with the car manufacturer.

3. Projection is not clear in bright environments – Ensure all transparent films are removed from the HUD unit and the HUD is projecting properly on the

projection reflector screen. Also, try adjusting the brightness setting.

4. HUD shuts down or crashes unexpectedly – Press and hold the function button along with the power button to reset the unit. Release the button

when the screen lights up. The unit has now been reset to factory settings.

Description

Increase or decrease the speed reading by pushing the FUNCTION BUT-

TON up or down. It is recommended to adjust in small increments each

time in order to fine-tune the reading. DO NOT ADJUST WHILE DRIVING.

With the car in park, gently step on the gas pedal to view the RPM

reading and adjust by pushing the FUNCTION BUTTON up or down until

it matches the vehicle techometer.

The factory preset is 5,000RPM. Adjust by pushing the FUNCTION BUT-

TON up or down.

The factory preset is 150km/h. Adjust by pushing the FUNCTION BUT-

TON up or down.

Select the desired setting by pushing the FUNCTION BUTTON up or

down.

0 = AUTO BRIGHTNESS

1 = DARKER

2 = BRIGHTER

Select the desired setting by pushing the FUNCTION BUTTON up or

down.

1 = KM

2 = MPH

Select the desired setting by pushing the FUNCTION BUTTON up or

down.

1 = °C

2 = °F

The factory preset automatically turns the HUD off 10 seconds after the

car is turned off (130 seconds for hybrid cars). Adjust by pushing the

FUNCTION BUTTON up or down.

Factory Preset