GAE GA1014 Ürün Kullanım Kılavuzu - Sayfa 7

Tuner GAE GA1014 için çevrimiçi göz atın veya pdf Ürün Kullanım Kılavuzu indirin. GAE GA1014 10 sayfaları. High power e-h tuner

Product User Manual

Model GA101x Series High Power E-H Tuner

Flange Alignment Pins

GA8401 Quick-Release clamp when connected to another similarly

designed flange. These flanges can also be connected to any other

standard WR284 round flange (UG-584/U) using suitable fastener

hardware.

Each waveguide flange connection that uses a quick-release clamp

requires two alignment pins for proper alignment of the adjacent

waveguide sections. All GAE waveguide components include one

alignment pin for each flange designed for use with quick-release

clamps. Alignment pins can be installed into either of two threaded

holes centered above and below the waveguide broadwalls. For

obvious reasons, the pins must not be installed such that they are

opposite each other on mating flanges.

Microwave Leakage – Regulatory limits for microwave leakage

relate to standards for human safety and interference with other

electronic devices. Standards for human safety as adopted by

OSHA, the International Electrotechnical Commission (IEC) and

other regulatory agencies limit leakage to 5 mW/cm

cm from the leakage source under normal operating conditions, and

10 mW/cm

at 5 cm from the source under abnormal operating

conditions. The U.S. Federal Communications Commission (FCC)

has established regulations limiting the emission of energy at

frequencies outside the ISM bands. All GAE waveguide

components meets these requirements when properly connected to

another waveguide component.

Page 7

measured at 5

Modesto, CA