DAW Industries TGK-4P10 Manuel - Sayfa 8

Tıbbi Ekipman DAW Industries TGK-4P10 için çevrimiçi göz atın veya pdf Manuel indirin. DAW Industries TGK-4P10 10 sayfaları.

Sayfayı Yazdır

Adjusting the Extension Stop Bumper

(Stability & Swing Phase Trigger Point)

To customize the "trigger point" of swing-phase, adjust the

Extension Stop Screw . Max adjustment is 2° .

Note: This adjustment will affect socket flexion slightly .

Turn the Extension Stop Screw (2.5mm hex):

Clockwise for earlier swing-phase initiation

(& less stance phase stability)

Counter-clockwise for later swing-phase initiation

(& more stance phase stability)

DAW

Industries

Extension Stop Screw

(2 .5mm hex)

For Technical Support call (800)242-8669

Cleaning Pneumatic Components

Using the Swing Adjustment Wrench (or 9mm wrench),

completely remove the Flexion Knob. Turn the Knob

counter-clockwise until it no longer appears to be

unthreading. The Knob pulls out of its chamber with a small

amount of force.

With the Knob removed, ﬂex the Knee quickly & repeatedly

to clear out any debris from the air passage. Air should ﬂow

smoothly with no restriction.

Using a Q-Tip, clean the chamber from which the Knob was

removed. The entire chamber should be dry.

Remove the Extension Screw (3mm Hex) from the Knob.

Remove the Needle and clean it of any debris or lubricant.

Apply a very light coat of wheel-bearing grease to the

Knob O-ring. Be sure the Needle remains dry.

Return the Needle to the Knob. Do not yet return the Screw

to the Knob. Press the Knob and Needle back into the

chamber of the knee. You will hear a "click" as the Knob

seats back into the chamber.

Turn the Flexion Knob clockwise. Initially, apply a small

amount of downward force while you turn to ensure the

threads catch. Gently screw it in until it stops. Do not tighten.

Turn the Knob counter-clockwise 2 rotations

(the factory setting for Extension).

While holding the Knob stationary with the Swing Adjustment

Wrench (or 9mm wrench), screw the Extension Screw back

into the Knob until 1 thread shows above the Knob

(the factory setting for Flexion).

Flexion Knob

(9mm)

DAW

Industries

Extension Screw

(3mm)

Needle

Knob O-ring

Apply wheel

bearing grease

For Technical Support call (800)242-8669

Clean