Gage Bilt 1753 Orijinal Talimat Kılavuzu - Sayfa 7

Araçlar Gage Bilt 1753 için çevrimiçi göz atın veya pdf Orijinal Talimat Kılavuzu indirin. Gage Bilt 1753 20 sayfaları. Installation tool

When the actuator lever assembly is depressed, the pressurized air inside of the tool is released allowing spring pressure to move the

valve spool assembly causing the air to be redirected. The air is directed to the top of the air piston assembly, moving it in a downward

direction. The air below the air piston assembly is then directed through the valve sleeve and exhausted out of the bottom of the tool.

Simultaneously, the piston rod assembly connected to the air piston assembly is also moving down, forcing hydraulic oil up and into

the front side of the head cylinder assembly, causing the piston to move to the rear of the head cylinder assembly. The internal components

of the attached nose assembly are also moving with the piston to start the fastener installation. When the fastener installation is

completed, the actuator lever assembly is released. Air pressure is then built up inside of the handle causing the valve spool assembly

to return to its original position and reversing the sequence directing air pressure to the rear of the head cylinder assembly, causing

the piston to move to the forward position.

PULL Cycle

Air exhaust

Piston Rod Assembly

moves down

Air Piston

moves down

GB722 S/N: 1753 AND ABOVE

PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.

PRINCIPLE OF OPERATION

Piston Rod Assembly

moves up

Air Piston

moves up

Air exhaust

Pressurized Oil

Pressurized Air

Unpressurized Oil

Unpressurized Air

Images may not reflect actual tool

RETURN Cycle

Air exhaust

REV. 5/22