Gage Bilt GB703 Kurulum Kılavuzu - Sayfa 7

Elektrikli Alet Gage Bilt GB703 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Gage Bilt GB703 20 sayfaları.

When the actuator lever assy is depressed, the pressurized air inside of the tool is released allowing spring pressure to move the

valve spool assy causing the air to be redirected. The air is directed to the top of the air piston assy, moving it in a downward

direction. The air below the air piston assy is then directed through the valve sleeve and exhausted out of the bottom of the tool.

Simultaneously, the piston rod assy, connected to the air piston assy, is also moving down, forcing hydraulic oil up and into the

front side of the head cylinder assy, causing the piston to move to the rear of the head cylinder assy. The internal components of the

attached nose assembly are also moving with the piston to start the fastener installation. When the fastener installation is

completed, the actuator lever assy is released. Air pressure is then built up inside of the handle assy causing the valve spool assy to

return to its original position and reversing the sequence directing air pressure to the rear of the head cylinder assy, causing the

piston to move to the forward position.

PULL Cycle

Air exhaust

Piston Rod Assy

moves down

Air Piston

moves down

S/N: 3191 AND ABOVE

PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.

PRINCIPLE OF OPERATION

Piston Rod Assy

moves up

Air Piston

moves up

Air exhaust

Pressurized Oil

Pressurized Air

Return Oil

Exhaust Air

Image may not reflect actual tool

RETURN Cycle

Air exhaust

4/12 Rev. 1/17