Gage Bilt GB734V Manuel - Sayfa 4

Elektrikli Alet Gage Bilt GB734V için çevrimiçi göz atın veya pdf Manuel indirin. Gage Bilt GB734V 11 sayfaları. Installation tool

Sayfayı Yazdır

DESCRIPTION

WARNING:

THE BALANCE OF THIS TOOL IS DESIGNED FOR HORIZONTAL USE AND IS NOT SUITED FOR ANY

OTHER APPLICATIONS. GAGE BILT WILL BE PLEASED TO ADVISE FOR YOUR SPECIFIC

APPLICATION.

The GB734V is a pneumatic-hydraulic tool designed specifically for the efficient installation of a wide range of

blind rivets. It weighs 6.25 lbs. and can be operated in any position with one hand. It has a 1.090" rivet setting

stroke and a rated pull load of 3000 pounds with 90 psi air pressure at the air inlet.

The GB734V riveter operates on a wide range of air pressure, with 90 to 100 psi providing the maximum

efficiency. At 90 psi air pressure, the GB734V does not exceed 81.5 db (A) and consumes 3 cfm at 20 cycles a

minute.

The air inlet is provided with 1/4-18 female pipe threads to accept the users air hose fitting.

UNLESS ORDERED RIVET SPECIFIC (I.E. GB734V/6P), THE STANDARD GB734V IS FURNISHED WITH NOSE

ASSEMBLY 8N-743A-24V AND WITH SPARE NOSE TIP 10204 TO CONVERT TO 6N-743A-24V NOSE

ASSEMBLY. ALL OTHER NOSE TIPS MUST BE ORDERED SEPARATELY. WHEN ORDERING TOOL RIVET

SPECIFIC, PLEASE CONTACT GAGE BILT FOR MORE INFORMATION. (See page 10 for nose assembly

recommendations.)

MAINTENANCE

WARNING:

EXCESSIVE CONTACT WITH HYDRAULIC FLUID AND LUBRICANTS SHOULD BE AVOIDED.

WARNING:

MAINTENANCE PERSONNEL

The performance of any tool depends upon good maintenance practices. Following these minimall

requirements for service and care will extend the life of your tool.

*Only use an air supply set at 90-100 psi. equipped with a filter-regulator to prevent wear.

*The tool will eventually lose some hydraulic oil. Keep the hydraulic system full and free of air by

using the air bleeder (704153) on a regular basis.

*Proper care by operator is necessary in maintaining full productivity and reducing downtime. Read all

applicable tool manuals and nose assembly data sheets prior to operating tools.

*Keep nose assemblies, especially jaws, clean and free of chips and debris. Lube jaws and collet surfaces

that jaws ride on with light machine oil.

*For a complete overhaul, tool kit GB740TK is recommended.

CLEANING AND LUBRICATING PROCEDURE

Daily cleaning and lubrication of nose assembly will

greatly reduce downtime and increase life of

components. Using sewing machine oil, or an

equivalent cleaner/lubricant, follow instructions

below.

1. Disconnect tool vacuum line (if equipped).

2. Point nose assembly into oil as shown.

3. Cycle tool 8-10 times and wipe dry.

TORQUE SPECIFICATIONS

Button Head Cap Screws (402479) = 40 inch lbs.

Packing Plug (744118) = 45 foot lbs.

Flexlock Nut (400559) = 40 inch lbs.

End Cap (734111-1) = 45 foot lbs.

Button Head Cap Screws (402482) = 35-40 inch lbs. (Do NOT over-tighten)

MUST

READ AND UNDERSTAND ALL WARNINGS AND CAUTIONS.

Image may not reflect actual tool

REV. 8/13