Gage Bilt GB510BOM Orijinal Talimat Kılavuzu - Sayfa 7
Perçin Aletleri Gage Bilt GB510BOM için çevrimiçi göz atın veya pdf Orijinal Talimat Kılavuzu indirin. Gage Bilt GB510BOM 20 sayfaları. Installation tool
Sayfayı YazdırWhen the tool is connected to a powerunit, operation is controlled by a actuator to the hydraulic hoses. The GB510ABOM incorporates
an air actuator to send a signal; the GB510BOM an electric actuator. When the button is depressed, a directional valve in the powerunit
directs oil to the front side of the piston forcing it and the nose assembly collet rearward. This action causes the jaws to clamp on the
fastener pintail and pull the sheets together. The anvil is forced over the collar, swaging it into locking grooves of the fastener. Further
force breaks the pintail off, approximately flush with the collar.
When the piston nears the end of its stroke it exposes flats on the back of the unloading valve. These flats "dump" oil back to the
powerunit tank. When the button is released the directional valve reverses oil flow to the back of the piston and pushes the nose
assembly off of the swaged fastener. The spent pintail is released and drops out the back of the tool.
PULL Cycle
Piston Travel
PULL Pressure
GB510BOM/GB510ABOM INSTALLATION TOOL: S/N 1001 AND ABOVE
CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS
PRINCIPLE OF OPERATION
HYDRAULIC DIAGRAM
Relief
Valve
RETURN Pressure
Pressurized Oil
Unpressurized Oil
Images may not reflect actual tool
7
RETURN Cycle
Piston Travel
11/20 REV 121/22