Gage Bilt GB704 Orijinal Talimat Kılavuzu - Sayfa 7
Perçin Aletleri Gage Bilt GB704 için çevrimiçi göz atın veya pdf Orijinal Talimat Kılavuzu indirin. Gage Bilt GB704 20 sayfaları. Installation tool
Ayrıca Gage Bilt GB704 için: Kurulum Kılavuzu (13 sayfalar), Manuel (14 sayfalar)
Sayfayı Yazdır
When the actuator lever assembly is depressed, the pressurized air inside of the tool is released allowing spring pressure to move the
valve spool assembly causing the air to be redirected. The air is directed to the top of the air piston assembly, moving it in a downward
direction. The air below the air piston assembly is then directed through the valve sleeve and exhausted out of the bottom of the tool.
Simultaneously, the piston rod assembly connected to the air piston assembly is also moving down, forcing hydraulic oil up and into the
front side of the head cylinder assembly, causing the piston to move to the rear of the head cylinder assembly. The internal components
of the attached nose assembly are also moving with the piston to start the fastener installation. When the fastener installation is completed,
the actuator lever assembly is released. Air pressure is then built up inside of the handle causing the valve spool assembly to return to its
original position and reversing the sequence directing air pressure to the rear of the head cylinder assembly, causing the piston to
move to the forward position.
Air exhaust
Piston Rod Assembly
moves down
Air Piston
moves down
GB704 S/N: 3213 AND ABOVE
PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.
PRINCIPLE OF OPERATION
PULL Cycle
Air exhaust
Pressurized Oil
Unpressurized Oil
Image may not reflect actual tool.
Piston Rod Assembly
moves up
Air Piston
moves up
Pressurized Air
Unpressurized Air
7
RETURN Cycle
Air exhaust
6/11 Rev. 5/22